Search results
Results from the WOW.Com Content Network
Electronic throttle control, throttle position sensor fault or cruise control failure (see drive by wire) [11] Stuck throttle (unrelated to pedal position) [12] [13] Shorting of tin whiskers [14] [15] Diesel engine runaway: Diesel engine power is governed by the amount of fuel supplied. Excessive pressure in the crankcase can force mist of ...
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
Kane alleged that the problem was not with the accelerator pedals, but with the electronic throttle control systems (ETC). [192] An electronic throttle control system is a drive-by-wire system, in which the accelerator pedal and the engine are indirectly linked electronically, instead of directly linked mechanically. [ 193 ]
Some engine control units (ECUs) also control the throttle position by electronic throttle control (ETC) or "drive by wire" systems, and if that is done, the position sensor is used in a feedback loop to enable that control. [1] Related to the TPS are accelerator pedal sensors, which often include a wide open throttle (WOT) sensor.
The advent of concern about fuel economy and emissions had major impacts on engine design. Some of the trade-offs reduced throttle response. Most new cars employ a drive-by-wire system, which includes electronic throttle control and can itself either reduce or increase throttle response (Depending on whether or not it's being employed on a performance car).
Lift-off oversteer (also known as trailing-throttle oversteer, throttle off oversteer, or lift-throttle oversteer) is a form of sudden oversteer.While cornering, a driver who closes the throttle (by lifting a foot off the accelerator, hence the name), usually at a high speed, can cause such sudden deceleration that the vertical load on the tires shifts from rear to front, in a process called ...
An electronic speed control (ESC) is an electronic circuit that controls and regulates the speed of an electric motor. It may also provide reversing of the motor and dynamic braking. Miniature electronic speed controls are used in electrically powered radio controlled models. Full-size electric vehicles also have systems to control the speed of ...
Many light aircraft use a push/pull Bowden cable for the throttle control, and here it is normal for the inner element to be a solid wire, rather than a multi-strand cable. Usually, provision is made for adjusting the cable tension using an inline hollow bolt (often called a "barrel adjuster"), which lengthens or shortens the cable housing ...