Search results
Results from the WOW.Com Content Network
The Smith & Wesson Model 3 is a single-action, cartridge-firing, top-break revolver produced by Smith & Wesson (S&W) from around 1870 to 1915, and was recently again offered as a reproduction by Smith & Wesson and Uberti.
The Webley is a top-break revolver and breaking the revolver operates the extractor, which removes cartridges from the cylinder. The Webley Mk I service revolver was adopted in 1887 and the Mk IV rose to prominence during the Boer War of 1899–1902 .
An IOF .32 top-break revolver. In a top-break revolver, the frame is hinged at the bottom front of the cylinder. Releasing the lock and pushing the barrel down exposes the rear face of the cylinder. In most top-break revolvers, this act also operates an extractor that pushes the cartridges in the chambers back far enough that they will fall ...
The final version of these top-break double-action 38's was the Perfected Model. This version used a top break with a sideplate thumb latch and was made from 1909 until 1920 for a total of 59,400 revolvers. This model was used by Floyd Allen in a courthouse escape attempt in 1913. [1]
The .45 Schofield / 11.5x27mmR, also referred to as .45 Smith & Wesson is a revolver cartridge developed by Smith & Wesson for their S&W Model 3 Schofield top-break revolver. It is similar to the .45 Colt cartridge, but with a shorter case and a larger rim. The. 45 Schofield will generally work in revolvers chambered for that cartridge; but the ...
The Model 1 + 1 ⁄ 2 had three issues. The first two (known as the first and second issues) were "tip-up" revolvers with the barrel release catch located on the side of the frame in front of the trigger, while the third (known as the "Model 1 + 1 ⁄ 2 Single Action Revolver") was a "top-break", with the barrel release catch located on the top of the frame, just in front of the hammer.
Close-up of an IOF 32 break-action revolver. The first break-action revolver was patented in France and Britain at the end of December in 1858 by Devisme. [1] A substantial hinge pin joins the two parts of the rifle or shotgun; the stock with its firing mechanism and the fore-piece and barrel, which hold the round to be fired.
In 1906 Albert James Aubrey, former plant superintendent for Wilkes-Barre Gun Co. and the designer of Aubrey shotguns, became the vice president of Meriden Firearms for Sears. Two years later he became president of the division, a position he held until 1916. [4] During his time at Sears, Aubrey filed for and received 8 patents related to ...