Search results
Results from the WOW.Com Content Network
Fault detection, isolation, and recovery (FDIR) is a subfield of control engineering which concerns itself with monitoring a system, identifying when a fault has occurred, and pinpointing the type of fault and its location. Two approaches can be distinguished: A direct pattern recognition of sensor readings that indicate a fault and an analysis ...
Depiction of the no fault found cycle. Each clockwise cycle after the initial is a waste of maintenance resource. As the figure shows once a fault has been reported, investigated, and no fault found any future problems caused by the fault cause additional work which is a waste of maintainer time. Different causes have been suggested for this issue.
This is usually handled with a separate "automated fault-detection system". In the case of the tire, an air pressure monitor detects the loss of pressure and notifies the driver. The alternative is a "manual fault-detection system", such as manually inspecting all tires at each stop. Interference with fault detection in another component.
A fault tree diagram. Fault trees are a logical inverse of success trees, and may be obtained by applying de Morgan's theorem to success trees (which are directly related to reliability block diagrams). FTA may be qualitative or quantitative. When failure and event probabilities are unknown, qualitative fault trees may be analyzed for minimal ...
Inflight maintenance checklist procedure before starting waste collection system repair on board the Atlantis shuttle. Corrective maintenance is a maintenance task performed to identify, isolate, and rectify a fault so that the failed equipment, machine, or system can be restored to an operational condition within the tolerances or limits established for in-service operations.
Fault reporting is a maintenance concept that increases operational availability and that reduces operating cost by three mechanisms: Reduce labor-intensive diagnostic evaluation; Eliminate diagnostic testing down-time; Provide notification to management for degraded operation; That is a prerequisite for condition-based maintenance. [1]
Watchdog timers are sometimes used to trigger the recording of system state information—which may be useful during fault recovery [4] —or debug information (which may be useful for determining the cause of the fault) onto a persistent medium. In such cases, a second timer—which is started when the first timer elapses—is typically used ...
Ideally, a fault management system should be able to correctly identify events and automatically take action, either launching a program or script to take corrective action, or activating notification software that allows a human to take proper intervention (i.e. send e-mail or SMS text to a mobile phone). Some notification systems also have ...