Search results
Results from the WOW.Com Content Network
Once the switch happens, green changes to red. This feature allows the presenter to be aware of the upcoming transition, and, for example, change their posture. In addition to the tally lights, an additional light called ISO is sometimes used. ISO is the abbreviation for isolated, and it indicates that the video signal is being recorded separately.
By the late 1990s, most new monitors implemented at least one DPMS level. [citation needed]DPMS does not define implementation details of its various power levels; [3] while in a CRT-based display the three steps could logically be mapped to three blocks to be shut down in order of increasing savings, thermal stress, and warm-up time (video amplifier, deflection, filaments) not all designs ...
A simple PoR uses the charging of a capacitor, in series with a resistor, to measure a time period during which the rest of the circuit is held in a reset state. A Schmitt trigger may be used to deassert the reset signal cleanly, once the rising voltage of the RC network passes the threshold voltage of the Schmitt trigger. The resistor and ...
An output signal switching device (OSSD) is an electronic device used as part of the safety system of a machine. It provides a coded signal which, when interrupted due to a safety event, signals the machine to shut down. It works by converting the standard direct current supply, usually 24 volts, into two pulsed and out-of-phase signals.
Most modern monitors will switch to a power-saving mode if no video-input signal is received. This allows modern operating systems to turn off a monitor after a specified period of inactivity. This also extends the monitor's service life. Some monitors will also switch themselves off after a time period on standby.
Display Data Channel (DDC) is a collection of protocols for digital communication between a computer display and a graphics adapter that enable the display to communicate its supported display modes to the adapter and that enable the computer host to adjust monitor parameters, such as brightness and contrast.
Coordinated Video Timings (CVT; VESA-2013-3 v1.2 [1]) is a standard by VESA which defines the timings of the component video signal. Initially intended for use by computer monitors and video cards , the standard made its way into consumer televisions .
Some modern monitors and video cards support reduced blanking, standardized with Coordinated Video Timings. [ 3 ] In the PAL television standard, the blanking level corresponds to the black level , whilst other standards, most notably some variants of NTSC, may set the black level slightly above the blanking level on a pedestal or "set up level".