Search results
Results from the WOW.Com Content Network
1.0 short cwt (100 lb; 45 kg) long quarter: long qtr long qtr 1.0 long qtr (28 lb; 13 kg) short quarter: short qtr short qtr 1.0 short qtr (25 lb; 11 kg) stone: st st 14 lb used mostly in the British Commonwealth except Canada 1.0 st (14 lb; 6.4 kg) st kg. st kg lb; st lb. st lb kg; pound: lb lb 1.0 lb (0.45 kg) lb kg. lb kg st; lb st. lb st kg ...
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
However, the names of all SI mass units are based on gram, rather than on kilogram; thus 10 3 kg is a megagram (10 6 g), not a *kilokilogram. The tonne (t) is an SI-compatible unit of mass equal to a megagram (Mg), or 10 3 kg. The unit is in common use for masses above about 10 3 kg and is often used with SI prefixes.
The table below lists units supported by {{convert}}. More complete lists are linked for each dimension. More complete lists are linked for each dimension. For a complete list of all dimensions, see full list of units .
Some options provide text that the template may mistakenly use for the output unit, if none is specified. That can be avoided by providing an empty output unit, as shown in the following examples. {{convert|4|ft}} → 4 feet (1.2 m)
Template talk:Convert • Questions on using the convert template, or discussion of any problems encountered, or proposals to add units or change convert; Wikipedia:Help desk • General questions; Module talk:Convert • Discussion concerning the convert modules (however, discussions relating to units should occur at Template talk:Convert)
The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...
Atmospheric pollutant concentrations expressed as mass per unit volume of atmospheric air (e.g., mg/m 3, μg/m 3, etc.) at sea level will decrease with increasing altitude because the atmospheric pressure decreases with increasing altitude. The change of atmospheric pressure with altitude can be obtained from this equation: [2]