Search results
Results from the WOW.Com Content Network
In modern mathematics, this formula can easily be computed using calculus — it is, up to scaling, the integral = Without using calculus, the formula can be proven by comparing the cone to a pyramid and applying Cavalieri's principle – specifically, comparing the cone to a (vertically scaled) right square pyramid, which forms one third of a ...
Cone – , where is the base ... List of volume formulas – Quantity of three-dimensional space; References This page was last edited on 16 June 2023, at 16:58 (UTC ...
The formula for the volume of a pyramidal square frustum was introduced by the ancient Egyptian mathematics in what is called the Moscow Mathematical Papyrus, written in the 13th dynasty (c. 1850 BC): = (+ +), where a and b are the base and top side lengths, and h is the height.
The disk-shaped cross-sectional area of the sphere is equal to the ring-shaped cross-sectional area of the cylinder part that lies outside the cone. If one knows that the volume of a cone is (), then one can use Cavalieri's principle to derive the fact that the volume of a sphere is , where is the radius.
A subset of a vector space over an ordered field is a cone (or sometimes called a linear cone) if for each in and positive scalar in , the product is in . [2] Note that some authors define cone with the scalar ranging over all non-negative scalars (rather than all positive scalars, which does not include 0). [3]
If the radius of the sphere is denoted by r and the height of the cap by h, the volume of the spherical sector is =. This may also be written as V = 2 π r 3 3 ( 1 − cos φ ) , {\displaystyle V={\frac {2\pi r^{3}}{3}}(1-\cos \varphi )\,,} where φ is half the cone aperture angle, i.e., φ is the angle between the rim of the cap and the ...
In algebraic geometry, a cone is a generalization of a vector bundle. Specifically, given a scheme X , the relative Spec C = Spec X R {\displaystyle C=\operatorname {Spec} _{X}R}
A conic is the curve obtained as the intersection of a plane, called the cutting plane, with the surface of a double cone (a cone with two nappes).It is usually assumed that the cone is a right circular cone for the purpose of easy description, but this is not required; any double cone with some circular cross-section will suffice.