Search results
Results from the WOW.Com Content Network
The Internet Assigned Numbers Authority (IANA) is responsible for maintaining the official assignments of port numbers for specific uses, [1] However, many unofficial uses of both well-known and registered port numbers occur in practice. Similarly, many of the official assignments refer to protocols that were never or are no longer in common use.
If UPnP is only used to control router port mappings and pinholes, there are alternative, newer much simpler and lightweight protocols such as the PCP and the NAT-PMP, both of which have been standardized as RFCs by the IETF. These alternatives are not yet known to have compatibility issues between different clients and servers, but adoption is ...
Local port forwarding is the most common type of port forwarding. It is used to let a user connect from the local computer to another server, i.e. forward data securely from another client application running on the same computer as a Secure Shell (SSH) client. By using local port forwarding, firewalls that block certain web pages, can be ...
UPnP logo as promoted by the UPnP Forum (2001–2016) and Open Connectivity Foundation (2016–present). Universal Plug and Play (UPnP) is a set of networking protocols on the Internet Protocol (IP) that permits networked devices, such as personal computers, printers, Internet gateways, Wi-Fi access points and mobile devices, to seamlessly discover each other's presence on the network and ...
Port Control Protocol (PCP) is a computer networking protocol that allows hosts on IPv4 or IPv6 networks to control how the incoming IPv4 or IPv6 packets are translated and forwarded by an upstream router that performs network address translation (NAT) or packet filtering.
A forwarding information base (FIB), also known as a forwarding table or MAC table, is most commonly used in network bridging, routing, and similar functions to find the proper output network interface controller to which the input interface should forward a packet. It is a dynamic table that maps MAC addresses to ports.
MAC-Forced Forwarding (MACFF) is used to control unwanted broadcast traffic and host-to-host communication. This is achieved by directing network traffic from hosts located on the same subnet but at different locations to an upstream gateway device. This provides security at Layer 2 since no traffic is able to pass directly between the hosts.
Bidirectional Forwarding Detection (BFD) is a network protocol that is used to detect faults between two routers or switches connected by a link. It provides low-overhead detection of faults even on physical media that doesn't support failure detection of any kind, such as Ethernet , virtual circuits , tunnels and MPLS label-switched paths .