Search results
Results from the WOW.Com Content Network
ID - A 16-bit identifier assigned by the program that generates any kind of query. QR - Query/Response. OPCODE - A 4-bit field that specifies the kind of query in this message. This value is set by the originator of a query and copied into the response. This specification defines the behavior of standard queries and responses (opcode value of ...
The ICMP header starts after the IPv4 header and is identified by its protocol number, 1. [6] All ICMP packets have an eight-byte header and variable-sized data section. The first four bytes of the header have fixed format, while the last four bytes depend on the type and code of the ICMP packet.
Ping operates by means of Internet Control Message Protocol (ICMP) packets. Pinging involves sending an ICMP echo request to the target host and waiting for an ICMP echo reply . The program reports errors, packet loss , and a statistical summary of the results, typically including the minimum, maximum, the mean round-trip times, and standard ...
ICMPv6 provides a minimal level of message integrity verification by the inclusion of a 16-bit checksum in its header. The checksum is calculated starting with a pseudo-header of IPv6 header fields according to the IPv6 standard, [6] which consists of the source and destination addresses, the packet length and the next header field, the latter of which is set to the value 58.
ICMP Internet Control Message Protocol: RFC 792: 0x02 2 IGMP Internet Group Management Protocol: RFC 1112: 0x03 3 GGP Gateway-to-Gateway Protocol: RFC 823: 0x04 4 IP-in-IP IP in IP (encapsulation) RFC 2003: 0x05 5 ST Internet Stream Protocol: RFC 1190, RFC 1819: 0x06 6 TCP Transmission Control Protocol: RFC 793: 0x07 7 CBT Core-based trees: RFC ...
A functionality which lets a computer A find out whether a computer B is reachable and responding is built into the Internet Control Message Protocol (ICMP). Through an "Echo Request" Computer A asks B to send back an "Echo Reply". [2] These two messages are also sometimes called "ping" and "pong" for historical purposes. [citation needed]
The server message is used to tell a server that the other end of a new connection is a server. [36] This message is also used to pass server data over the whole network. <hopcount> details how many hops (server connections) away <servername> is. <info> contains addition human-readable information about the server. Defined in RFC 1459.
Connection: Control options for the current connection and list of hop-by-hop request fields. [13] Must not be used with HTTP/2. [14] Connection: keep-alive. Connection: Upgrade. Permanent RFC 9110: Content-Encoding: The type of encoding used on the data. See HTTP compression. Content-Encoding: gzip: Permanent RFC 9110: Content-Length