enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Flange nut - Wikipedia

   en.wikipedia.org/wiki/Flange_nut

   Serrated flange nuts. A flange nut is a nut that has a wide flange at one end that acts as an integrated washer.This serves to distribute the pressure of the nut over the part being secured, reducing the chance of damage to the part and making it less likely to loosen as a result of an uneven fastening surface.

3. Computer case screws - Wikipedia

   en.wikipedia.org/wiki/Computer_case_screws

   The bolt end is typically hex-shaped, but may exceptionally be round to make removal more difficult. The hex diameter is 3/16", or 4.7mm. A 5mm hex socket might still fit, however where tightening or removal is required, care needs to be taken to select a nut driver with a sufficiently small outer diameter, as clearance between the jackpost and ...

4. Nut (hardware) - Wikipedia

   en.wikipedia.org/wiki/Nut_(hardware)

   Acorn nut (cap nut) Crown hex nut, blind nut, cap nut, domed cap nut, or dome nut A nut that has a domed end on one side Barrel nut: Steel cross dowel or dowel nut, cross dowel (woodworking) A round slug or formed sheet metal part with threads perpendicular to the length of the nut Cage nut: Caged nut, captive nut, clip nut

5. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   They may either have a Phillips flat head or a slotted hex washer head. Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole ...

6. Bolted joint - Wikipedia

   en.wikipedia.org/wiki/Bolted_joint

   Holes are drilled in nuts and bolt heads, and wire is threaded through the holes to prevent back-rotation. This method of locking is labor intensive, but is still used on critical joints. [1] Locknuts Some portion of the nut deforms elastically during tightening to provide a locking action. Spring washers and lock washers

7. Set screw - Wikipedia

   en.wikipedia.org/wiki/Set_screw

   Isometric projection of a grub screw with a hex socket head. Set screws are not always the best way to resist the torque of driven shafts. To reduce the chance of slipping and to increase load capacity, a detent (often called a "flat") may be milled or ground at the part of the shaft where the set screw's point contacts. The detent, however ...