Search results
Results from the WOW.Com Content Network
Dual, Quad and Octal 5 V PCI bus UARTs with 16C550 Compatible Registers, 64-byte Transmit and Receive FIFOs, Transmit and Receive FIFO Level Counters, Automatic RTS/CTS or DTR/DSR Flow Control, Automatic Xon/Xoff Software Flow Control, RS485 Half-duplex Control with Selectable Delay, Infrared (IrDA 1.0) Data Encoder/Decoder, Programmable Data ...
The USART's synchronous capabilities were primarily intended to support synchronous protocols like IBM's synchronous transmit-receive (STR), binary synchronous communications (BSC), synchronous data link control (SDLC), and the ISO-standard high-level data link control (HDLC) synchronous link-layer protocols, which were used with synchronous voice-frequency modems.
Optional CIC61508 safety monitor. Arduino IDE supported via add-in, plus Eclipse-based tools with multicore debugger. MBZ Pro WiFi Atmega328P-PU MaxBlitz: MBZ Pro Mega is an Arduino compatible stand-alone board with a prototyping area and built-in Wi-Fi. Featuring a compact design, it helps to shrink Arduino projects and make it permanent.
Automatic baud rate detection (ABR, autobaud) refers to the process by which a receiving device (such as a modem) determines the speed, code level, start bit, and stop bits of incoming data by examining the first character, usually a preselected sign-on character on a UART connection. ABR allows the receiving device to accept data from a ...
The AVRISP and AVRISP mkII are inexpensive tools allowing all AVRs to be programmed via ICSP. The AVRISP connects to a PC via a serial port and draws power from the target system. The AVRISP allows using either of the "standard" ICSP pinouts, either the 10-pin or 6-pin connector. The AVRISP mkII connects to a PC via USB and draws power from USB.
Serial communication on pin D0 (RX) and pin D1 (TX). used to receive (RX) and transmit (TX) TTL serial data. These pins are connected to the corresponding pins of the FTDI USB-to-TTL Serial chip. By sliding the switch (S1), RX/TX pins can be re-routed to Bluetooth UART connector. Linduino One Linear Technology Corporation [60] Yes ATmega328 16 MHz
Typically a command byte is sent requesting a response in dual mode, after which the MOSI line becomes SIO0 (serial I/O 0) and carries even bits, while the MISO line becomes SIO1 and carries odd bits. Data is still transmitted most-significant bit first, but SIO1 carries bits 7, 5, 3 and 1 of each byte, while SIO0 carries bits 6, 4, 2 and 0.
SDI-12 (Serial Digital Interface at 1200 baud) is an asynchronous serial communications protocol for intelligent sensors that monitor environment data. These instruments are typically low-power (12 volts), are used at remote locations, and usually communicate with a data logger or other data acquisition device.