Search results
Results from the WOW.Com Content Network
In fluid dynamics, normalized root mean square deviation (NRMSD), coefficient of variation (CV), and percent RMS are used to quantify the uniformity of flow behavior such as velocity profile, temperature distribution, or gas species concentration. The value is compared to industry standards to optimize the design of flow and thermal equipment ...
Note that, for the case of ligands (contrary to proteins, as described above), their structures are most commonly not superimposed prior to the calculation of the RMSD. RMSD is also one of several metrics that have been proposed for quantifying evolutionary similarity between proteins, as well as the quality of sequence alignments.
A similar calculation indicates that the peak mains voltage in Europe is about 325 volts, and the peak-to-peak mains voltage, about 650 volts. RMS quantities such as electric current are usually calculated over one cycle. However, for some purposes the RMS current over a longer period is required when calculating transmission power losses.
True RMS provides a more correct value that is proportional to the square root of the average of the square of the curve, and not to the average of the absolute value. For any given waveform , the ratio of these two averages is constant and, as most measurements are made on what are (nominally) sine waves, the correction factor assumes this ...
The maximum is taken over all possible structure superpositions of the model and template (or some sample thereof). When comparing two protein structures that have the same residue order, reads from the C-alpha order number of the structure files (i.e., Column 23-26 in Protein Data Bank (file format)).
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
According to the New York Times, here's exactly how to play Strands: Find theme words to fill the board. Theme words stay highlighted in blue when found.
Contemporary electronic RMS detectors had "normal", linear outputs, and were built exactly following the definition of RMS. The detector would compute square of the input signal, time-average the square using a low-pass filter or an integrator, and then compute square root of that average to produce linear, not logarithmic, output.