Search results
Results from the WOW.Com Content Network
Engines that do not have a water cooling system cannot heat the cabin via a heater core; one alternative is to guide air around the (very hot) engine exhaust manifold and then into the vehicle's interior. Temperature control is achieved by mixing with unheated outside air. Air-cooled Volkswagen engines use this method.
However, once water boils, it is an insulator, leading to a sudden loss of cooling where steam bubbles form. Steam may return to water as it mixes with other coolant, so an engine temperature gauge can indicate an acceptable temperature even though local temperatures are high enough that damage is being done. An engine needs different temperatures.
A temperature switch or a thermistor can control the evaporator coil surface temperature, and a pressure switch or sensing element can monitor the suction pressure (which is in relationship with the refrigerant's evaporating temperature). Both control means can act (either directly or by means of a control unit fed by their data) upon the ...
a thermostat to control temperature by varying the amount of coolant going to the radiator; a fan to draw cool air through the radiator. The combustion process produces a large amount of heat. If heat were allowed to increase unchecked, detonation would occur, and components outside the engine would fail due to excessive temperature. To combat ...
Cooling is required to remove excessive heat—high temperature can cause engine failure, usually from wear (due to high-temperature-induced failure of lubrication), cracking or warping. Two most common forms of engine cooling are air-cooled and water-cooled. Most modern automotive engines are both water and air-cooled, as the water/liquid ...
The temperature range lies between the minimum and maximum operating temperature of the element. Elements can cover temperatures ranging from -15 °C to +120 °C. Elements may move in proportion to the temperature change over some part of the range, or may open suddenly around a particular temperature depending on the composition of the waxes.
Temperature in each zone may be adjusted by adding small amounts of trim air, which is low-pressure, high-temperature air tapped off the AC PACK upstream of the TCV. Air is also supplied to individual gasper vents. [a] A revolving control on the vent can be turned to adjust ventilation between no air output at all and a fairly substantial breeze.
Device to measure the temperature to which the coolant protects the car from freezing. Water is the most common coolant. Its high heat capacity and low cost make it a suitable heat-transfer medium. It is usually used with additives, like corrosion inhibitors and antifreeze.