Ad
related to: what a resistor does a switch cover
Search results
Results from the WOW.Com Content Network
When the switch is open the voltage of the gate input is pulled up to the level of Vin. When the switch is closed, the input voltage at the gate goes to ground. In electronic logic circuits, a pull-up resistor (PU) or pull-down resistor (PD) is a resistor used to ensure a known state for a signal. [1]
For example, a 10 ohm resistor connected in parallel with a 5 ohm resistor and a 15 ohm resistor produces 1 / 1/10 + 1/5 + 1/15 ohms of resistance, or 30 / 11 = 2.727 ohms. A resistor network that is a combination of parallel and series connections can be broken up into smaller parts that are either one or the other.
As an introduction to the next chapter, this figure shows that the term "shunt resistor" should be understood in the context of what it shunts. In this example the resistor R L would be understood as "the shunt resistor" (to the load L), because this resistor would pass current around the load L. R L is connected in parallel with the load L.
Ceramic backed with glass hermetic seal cover. Thick film resistors became popular during the 1970s, and most SMD (surface mount device) resistors today are of this type. The resistive element of thick films is 1000 times thicker than thin films, [ 7 ] but the principal difference is how the film is applied to the cylinder (axial resistors) or ...
A toggle DIP switch with four inputs and outputs Bank of toggle switches on a Data General Nova minicomputer front panel Toggle switches with the shared cover preventing certain forbidden combinations. A toggle switch or tumbler switch is a class of electrical switches that are manually actuated by a mechanical lever, handle, or rocking mechanism.
The most widely used electronic switch in digital circuits is the metal–oxide–semiconductor field-effect transistor (MOSFET). [2] The analogue switch uses two MOSFET transistors in a transmission gate arrangement as a switch that works much like a relay, with some advantages and several limitations compared to an electromechanical relay.
When a conductor has spatial dimensions close to /, where is Fermi wavevector of the conducting material, Ohm's law does not hold anymore. These small devices are called quantum point contacts . Their conductance must be an integer multiple of the value 2 e 2 / h {\displaystyle 2e^{2}/h} , where e {\displaystyle e} is the elementary charge and ...
An analogue switch: Maxim MAX313. An analogue switch, also called a bilateral switch, is an electronic component that behaves in a similar way to a relay, but has no moving parts. The switching element is normally a pair of MOSFET transistors, one an N-channel device, the other a P-channel device. The device can conduct analog or digital ...
Ad
related to: what a resistor does a switch cover