Search results
Results from the WOW.Com Content Network
Most pushrod engines, where the crankshaft and camshaft are very close together, use a short chain drive rather than a direct gear drive. This is because gear drives suffer from frequent torque reversal as the cam profiles "kick back" against the drive from the crank, leading to excessive noise and wear. [citation needed]
The Hyundai Beta engines are 1.6 L to 2.0 L I4 built in Ulsan, South Korea.. All Beta engines are dual overhead camshaft valvetrain design.The Beta engine uses a direct-acting overhead cam valvetrain arrangement which places the camshaft in the cylinder head above the pistons and combustion chamber and operates the valve tappets/lifters directly.
The active valve control system (AVCS) is an automobile variable valve timing technology used by Subaru. It varies the timing of the valves by using hydraulic oil pressure to rotate the camshaft, known as "phasing", [1] in order to provide optimal valve timing for engine load conditions. The system is closed loop using the camshaft sensors ...
For twin-cam or DOHC engines, VCT was used on either the intake or exhaust camshaft. (Engines that have VCT on both camshafts are now designated as Ti-VCT.↓) The use of variable camshaft timing on the exhaust camshaft is for improved emissions, and vehicles with VCT on the exhaust camshaft do not require exhaust gas recirculation (EGR) as retarding the exhaust cam timing achieves the same ...
Torque: 10.0 kg⋅m (98 N⋅m; 72 lb⋅ft) at 4,000 rpm ... Fuel Control: OBD-1 MPFI; The camshaft is the same as D16A6 ... Rubber plug where cam angle sensor would ...
In a diesel, the sensor will control the fuel injection. The sensor output may also be related to other sensor data including the cam position to derive the current combustion cycle, this is very important for the starting of a four-stroke engine. Sometimes, the sensor may become burnt or worn out - or just die of old age at high mileage.
SOHC design (for a 1973 Triumph Dolomite Sprint) . The oldest configuration of overhead camshaft engine is the single overhead camshaft (SOHC) design. [1] A SOHC engine has one camshaft per bank of cylinders, therefore a straight engine has a total of one camshaft and a V engine or flat engine has a total of two camshafts (one for each cylinder bank).
The cam can be seen as a device that converts rotational motion to reciprocating (or sometimes oscillating) motion. [clarification needed] [3] A common example is the camshaft of an automobile, which takes the rotary motion of the engine and converts it into the reciprocating motion necessary to operate the intake and exhaust valves of the cylinders.