Search results
Results from the WOW.Com Content Network
Similar to 1:64. 1:64: 4.763 mm Ships, die-cast cars. Matchbox and Hot Wheels use this scale to describe their vehicles, although the actual scale of the individual models varies from 1:55 to beyond 1:100. Same as S Scale. Also called 3 ⁄ 16 in. scale. Known as 25 mm figure scale in wargaming circles. [12] 1:60.96: 5.000 mm
For Morse taper-shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to 3¼ inches, and a single 1/4 inch increment to 3½ inches. One aspect of this method of sizing is that the size increment between drill bits ...
By the 1990s, they were called 28 mm. figures, and have largely replaced 25s as the standard size for role-playing and many military games. Accessories scaled to match 28 mm gaming figures are generally built to 1:64 scale. More accurate to 1/64 scale car models would be the 20mm figures, or approximately 1/72.
One scale inch is equivalent to approximately 1/200 of an inch, 0.005 inches and 25.4 millimetres. One scale foot is equivalent to approximately 12/200 of an inch, 0.06 inches and 1.524 millimetres. One scale yard is equivalent to approximately 1/36 of an inch, 0.18 inches and 4.572 millimetres.
Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.
25.4 μm: A thousandth of an inch is a derived unit of length in a system of units using inches. Equal to 1 ... 1 ⁄ 8, 1 ⁄ 16, 1 ⁄ 32, 1 ⁄ 64). Each 64th is ...
Originally in 1945, the divisions were based on the ring inside diameter in steps of 1 ⁄ 64 inch (0.40 mm). [6] However, in 1987 BSI updated the standard to the metric system so that one alphabetical size division equals 1.25 mm of circumferential length.
The diameters are sometimes given approximately in fractions of an inch (e.g. the major diameter of a #6 screw is 0.1380 in, approximately 9 ⁄ 64 in = 0.140625 in. The pitch P is the distance between thread peaks.