Search results
Results from the WOW.Com Content Network
A Kelvin bridge, also called a Kelvin double bridge and in some countries a Thomson bridge, is a measuring instrument used to measure unknown electrical resistors below 1 ohm. It is specifically designed to measure resistors that are constructed as four terminal resistors.
Four-point measurement of resistance between voltage sense connections 2 and 3. Current is supplied via force connections 1 and 4. In electrical engineering, four-terminal sensing (4T sensing), 4-wire sensing, or 4-point probes method is an electrical impedance measuring technique that uses separate pairs of current-carrying and voltage-sensing electrodes to make more accurate measurements ...
In power supply design, a bridge circuit or bridge rectifier is an arrangement of diodes or similar devices used to rectify an electric current, i.e. to convert it from an unknown or alternating polarity to a direct current of known polarity. In some motor controllers, an H-bridge is used to control the direction the motor turns.
The final stage of a Kelvin–Varley divider is just a Kelvin divider. For a decade divider, there will be ten equal value resistors. Let the value of each resistor be R n Ohms. The input impedance of the entire string will be 10 R n. Alternatively, the last stage can be a two resistor bridge tap.
The Kelvin water dropper, invented by Scottish scientist William Thomson (Lord Kelvin) in 1867, [1] is a type of electrostatic generator. Kelvin referred to the device as his water-dropping condenser. The apparatus is variously called the Kelvin hydroelectric generator, the Kelvin electrostatic generator, or Lord Kelvin's thunderstorm.
A Maxwell-Wien bridge. A Maxwell bridge is a modification to a Wheatstone bridge used to measure an unknown inductance (usually of low Q value) in terms of calibrated resistance and inductance or resistance and capacitance. [1] When the calibrated components are a parallel resistor and capacitor, the bridge is known as a Maxwell bridge.
The Schering bridge is an electrical circuit used for measuring the insulating properties of electrical cables and equipment. [1] It is an AC bridge circuit , developed by Harald Schering . It has the advantage that the balance equation is independent of frequency.
Kelvin Hughes Type 14/9 Radar from front Kelvin Hughes Type 14/9 Radar from side. The Kelvin connection is based upon the professional relationship between William Thomson (later-Lord Kelvin) (1824–1907), Professor of Natural Philosophy at Glasgow University from 1846–1899 and James White (1824–1884), a Glasgow-based Optical Instrument Maker.