enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Glass cutter - Wikipedia

   en.wikipedia.org/wiki/Glass_cutter

   The greater the hone angle of the wheel, the sharper the angle of the V and the thicker the piece of glass it is designed to cut. The hone angle on most hand-held glass cutters is 120° to 140°, though wheels are made as near-flat as 154° or even 160° [180° would be flat like a roller] for cutting glass as thick as 0.5 inches (13 mm). [4]

3. Sight glass - Wikipedia

   en.wikipedia.org/wiki/Sight_glass

   The gauge glass on a boiler needs to be inspected periodically and replaced if it is seen to have worn thin in the vicinity of the gland nuts, but a failure in service can still occur. Drivers are expected to carry two or three glass tubes, pre-cut to the required length, together with hemp or rubber seals, to replace the tubes on the road. [1]

4. Scoring knife - Wikipedia

   en.wikipedia.org/wiki/Scoring_knife

   A scoring knife or scoring tool is a handheld tool used to cut a groove in a sheet of material. The cutting edge of the knife is often made of hard material such tungsten carbide. The scoring knife is drawn across the material in a straight line (with the help of a straightedge), creating a scratch or score in the sheet. The material can then ...

5. Diagonal pliers - Wikipedia

   en.wikipedia.org/wiki/Diagonal_pliers

   Diagonal pliers (also known as wire cutters or diagonal cutting pliers, or under many regional names) are pliers intended for the cutting of wire or small stock, rather than grabbing or turning. The plane defined by the cutting edges of the jaws intersects the joint rivet at an angle or "on a diagonal", giving pliers their name.

6. Gauge (instrument) - Wikipedia

   en.wikipedia.org/wiki/Gauge_(instrument)

   Dial indicator, also known as a dial test indicator, dial gauge, or probe indicator an instrument used to accurately measure small linear distances. Feeler gauge: a simple tool used to measure gap widths. Gauge block, (also known as a gage block, Johansson gauge, slip gauge, or Jo block) a precision ground and lapped length measuring standard.

7. Guillotine cutting - Wikipedia

   en.wikipedia.org/wiki/Guillotine_cutting

   Guillotine cutting is the process of producing small rectangular items of fixed dimensions from a given large rectangular sheet, using only guillotine-cuts. A guillotine-cut (also called an edge-to-edge cut) is a straight bisecting line going from one edge of an existing rectangle to the opposite edge, similarly to a paper guillotine.