enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Power over Ethernet - Wikipedia

    en.wikipedia.org/wiki/Power_over_Ethernet

    In Mode A, pins 1 and 2 (pair 3 in T568A wiring, pair 2 in T568B) form one side of the 48 V DC, and pins 3 and 6 (pair 2 in T568A, pair 3 in T568B) form the other side. These are the same two pairs used for data transmission in 10BASE-T and 100BASE-TX, allowing the provision of both power and data over only two pairs in such networks.

  3. Y-cable - Wikipedia

    en.wikipedia.org/wiki/Y-cable

    A Shure FP24 preamp's mono XLR line outputs connected to an Edirol R-09 recorder's 3.5mm stereo jack line input, using a Y-cable. This is an example of consolidating connectors, as described below. A Y-cable, Y cable, or splitter cable is a cable with three ends: one common end and two other ends. The Y-cable can resemble the Latin letter "Y".

  4. DSL filter - Wikipedia

    en.wikipedia.org/wiki/DSL_filter

    If Category 3 cable, Category 4 cable, or Category 5 cable was used to wire the premises and at least one pair of wires in the cable is unused, a "whole house" DSL filter can be installed at the point of entry, usually a Network Interface Device (NID) box. Although an in-line filter could be used for this purpose, special whole-house filters ...

  5. Power dividers and directional couplers - Wikipedia

    en.wikipedia.org/wiki/Power_dividers_and...

    A 10 dB 1.7–2.2 GHz directional coupler. From left to right: input, coupled, isolated (terminated with a load), and transmitted port. A 3 dB 2.0–4.2 GHz power divider/combiner. Power dividers (also power splitters and, when used in reverse, power combiners) and directional couplers are passive devices used mostly in the field of radio ...

  6. DMX512 - Wikipedia

    en.wikipedia.org/wiki/DMX512

    Signal Common (0 V) for Data 2 The 8P8C modular connector pinout matches the conductor pairing scheme used by Category 5 (Cat5) twisted pair patch cables. The avoidance of pins 4 and 5 helps to prevent equipment damage, if the cabling is accidentally plugged into a single-line public switched telephone network phone jack.

  7. USB hardware - Wikipedia

    en.wikipedia.org/wiki/USB_hardware

    The USB Power Delivery specification revision 2.0 (USB PD Rev. 2.0) has been released as part of the USB 3.1 suite. [ 57 ] [ 64 ] [ 65 ] It covers the USB-C cable and connector with a separate configuration channel, which now hosts a DC coupled low-frequency BMC -coded data channel that reduces the possibilities for RF interference . [ 66 ]

  8. ANSI/TIA-568 - Wikipedia

    en.wikipedia.org/wiki/ANSI/TIA-568

    A cable terminated according to T568A on one end and T568B on the other is a crossover cable when used with the earlier twisted-pair Ethernet standards that use only two of the pairs because the pairs used happen to be pairs 2 and 3, the same pairs on which T568A and T568B differ. Crossover cables are occasionally needed for 10BASE-T and ...

  9. List of video connectors - Wikipedia

    en.wikipedia.org/wiki/List_of_video_connectors

    1 Mini-DIN 4-pin, 1 Mini-DIN 7-pin, 1 Mini-VGA, 2 BNC, 2 RCA connectors, 8-pin DIN, [4] SCART 21-pin: S-VHS, some laptop computers, analog broadcast video, 1980-1990s home computers including the Commodore 64, C128 and Atari 8-bit computers: The 4-pin mini-DIN that is most common in consumer products today debuted in JVC's 1987 S-VHS. The 7-pin ...

  1. Related searches cable splitter specifications guide free download for pc 1 19 2 forge 43 3 0

    dsl splittertv power splitter diagram
    power splitter isolationwhat is a power splitter