Search results
Results from the WOW.Com Content Network
A centimetre of water [1] is a unit of pressure. It may be defined as the pressure exerted by a column of water of 1 cm in height at 4 °C (temperature of maximum density) at the standard acceleration of gravity, so that 1 cmH 2 O (4°C) = 999.9720 kg/m 3 × 9.80665 m/s 2 × 1 cm = 98.063754138 Pa ≈ 98.0638 Pa, but conventionally a nominal maximum water density of 1000 kg/m 3 is used, giving ...
The United States Energy Policy Act of 1992 mandated the first maximum water efficiencies for major fixtures in residential and commercial applications. [1] The energy policy EPAct 1992 for residential buildings, restricted toilets to a maximum of 1.6 gpf (Gallons per flush). Kitchen and bathroom faucets were limited to a flow rate of 2.2 gpm ...
It is defined as the pressure exerted by a column of water of 1 inch in height at defined conditions. At a temperature of 4 °C (39.2 °F) pure water has its highest density (1000 kg/m 3). At that temperature and assuming the standard acceleration of gravity, 1 inAq is approximately 249.082 pascals (0.0361263 psi). [2]
A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...
Each load uses on average 29.3 gallons (111 liters) of water. According to EPA, a full-sized Energy Star certified clothes washer (with "water factor" - WF ≤ 8.0 gal/cycle/ft^3) should use on average 15 gallons (57 liters) of water per load, compared to at least two times that volume used by a standard machine. [14]
The miner’s inch measures the amount of water that would flow through a slot of a given area at a given pressure (for example, at a head of 6 inches of water, or 1.5 kPa.) In miner's inch the word inch refers to the area of the slot in square inches, while the pressure in inches of water refers to the height of water above the slot. A ...
A typical residential water meter. Water metering is the practice of measuring water use. Water meters measure the volume of water used by residential and commercial building units that are supplied with water by a public water supply system. They are also used to determine flow through a particular portion of the system.
SG is the specific gravity of the fluid (for water = 1), ΔP is the pressure drop across the valve (expressed in psi). In more practical terms, the flow coefficient C v is the volume (in US gallons) of water at 60 °F (16 °C) that will flow per minute through a valve with a pressure drop of 1 psi (6.9 kPa) across the valve.