Search results
Results from the WOW.Com Content Network
In computing, traceroute and tracert are diagnostic command-line interface commands for displaying possible routes (paths) and transit delays of packets across an Internet Protocol (IP) network. The command reports the round-trip times of the packets received from each successive host (remote node) along the route to a destination.
The ICMP header starts after the IPv4 header and is identified by its protocol number, 1. [6] All ICMP packets have an eight-byte header and variable-sized data section. The first four bytes of the header have fixed format, while the last four bytes depend on the type and code of the ICMP packet.
Loose Source Routing is an IP option which can be used for address translation. LSR is also used to implement mobility in IP networks. [3] Loose source routing uses a source routing option in IP to record the set of routers a packet must visit. The destination of the packet is replaced with the next router the packet must visit.
The header contains information about IP version, source IP address, destination IP address, time-to-live, etc. The payload of an IP packet is typically a datagram or segment of the higher-level transport layer protocol, but may be data for an internet layer (e.g., ICMP or ICMPv6) or link layer (e.g., OSPF) instead.
Path MTU Discovery (PMTUD) is a standardized technique in computer networking for determining the maximum transmission unit (MTU) size on the network path between two Internet Protocol (IP) hosts, usually with the goal of avoiding IP fragmentation. PMTUD was originally intended for routers in Internet Protocol Version 4 (IPv4). [1]
A unique local address (ULA) is an Internet Protocol version 6 (IPv6) address in the address range fc00:: / 7. [1] These addresses are non-globally reachable [ 2 ] (routable only within the scope of private networks, but not the global IPv6 Internet).
These addresses are not routed on the Internet and thus their use need not be coordinated with an IP address registry. Any user may use any of the reserved blocks. Typically, a network administrator will divide a block into subnets; for example, many home routers automatically use a default address range of 192.168.0.0 through 192.168.0.255 ...
These meanings may not be consistent between operating systems. In both Windows and Linux, when selecting which of a host's IP address to use as a source IP, a program may specify INADDR_ANY (0.0.0.0). [3] [4] In Linux a program may specify 0.0.0.0 as the remote address to connect to the current host (AKA localhost). [2]