Search results
Results from the WOW.Com Content Network
[1] [3] Though NTLDR and boot.ini are no longer used to boot Windows Vista and later versions of Windows NT, they ship with the bootcfg utility regardless. This is to handle boot.ini in the case that a multi-boot configuration with previous versions of Windows exists and needs troubleshooting from within the later operating system.
EasyBCD has a number of bootloader-related features that can be used to repair and configure the bootloader. From the "Manage Bootloader" section of EasyBCD, it is possible to switch between the BOOTMGR bootloader (used since Windows Vista) and the NTLDR bootloader (used by legacy versions of Windows, from Windows NT to Windows XP) in the MBR from within Windows by simply clicking a button.
In Windows 3.1, additional options are available, such as /3, which starts Windows in 386 enhanced mode, and /S, which starts Windows in standard mode [2] A startup sound was first added in Windows 3.0 after installing the Multimedia Extensions (MME), [ 3 ] but not enabled by default until Windows 3.1.
bootcfg /ems on /port com1 /baud 9600 /id 1 On Windows Vista it is enabled by typing the following command where {default} is the OS entry in BCDedit: bcdedit /bootems {default} on In Windows Vista the serial port settings, Baud rate and Port ID, are accessed and modified using the following command:
On system with BIOS firmware, the BIOS invokes MBR boot code from a hard disk drive at startup. The MBR boot code and the VBR boot code are OS-specific. In Microsoft Windows, the MBR boot code tries to find an active partition (the MBR is only 512 bytes), then executes the VBR boot code of an active partition.
Microsoft Windows' safe mode (for 7/Vista [1] /XP [2] /2000/ME/98/95 [citation needed]) is accessed by pressing the F8 key as the operating system boots. [3] Also, in a multi-boot environment with multiple versions of Windows installed side by side, the F8 key can be pressed at the OS selector prompt to get to safe mode.
This is not a crash screen, however; upon crashing, Windows 1.0 would simply lock up or exit to DOS. This behavior is also present in Windows 2.0 and Windows 2.1 . Windows 3.0 uses a text-mode screen for displaying important system messages, usually from digital device drivers in 386 Enhanced Mode or other situations where a program could not run.
The default OperandSize and AddressSize to use for each instruction is given by the D bit of the segment descriptor of the current code segment - D=0 makes both 16-bit, D=1 makes both 32-bit. Additionally, they can be overridden on a per-instruction basis with two new instruction prefixes that were introduced in the 80386: