Ads
related to: can speakers be repaired
Search results
Results from the WOW.Com Content Network
However, it was often fragile and deteriorated on NS-2000 speakers. Fortunately, replacement of the edge can be done by speaker repair shops and the woofer can then continue working well. The frequency response of the woofer is rated down to 28 Hz, making the NS-2000 a full-range speaker that may not need a separate subwoofer for low ...
First, a restoration can be completed if "the instrument is mass-produced." Second, if "the instrument has been previously restored and most ephemeral has been lost." Third, with a little bit of work from a conservator, "the instrument can easily be put into working condition." Fourth, "the original function can be reestablished."
The term loudspeaker may refer to individual transducers (also known as drivers) or to complete speaker systems consisting of an enclosure and one or more drivers.. To adequately and accurately reproduce a wide range of frequencies with even coverage, most loudspeaker systems employ more than one driver, particularly for higher sound pressure level (SPL) or maximum accuracy.
Thiel Audio first exhibited at the Consumer Electronics Show in 1977 (the year the company was commonly stated as being founded, although they had been selling since 1976) [5] with the introduction of the 01 full-range speaker. A year later, in 1978, the model 03 introduced the principles of time, phase, and frequency coherence, which would ...
Klipsch Audio Technologies / ˈ k l ɪ p ʃ / (also referred to as Klipsch Speakers or Klipsch Group, Inc.) is an American loudspeaker company based in Indianapolis, Indiana.Founded in Hope, Arkansas, in 1946 as 'Klipsch and Associates' by Paul W. Klipsch, the company produces loudspeaker drivers and enclosures, as well as complete loudspeakers for high-end, high-fidelity sound systems, public ...
Magnepan has used several different technologies in constructing their magnetostatic speakers.All Magnepan speakers are based on flexible ferrite magnet strips (like refrigerator magnets), 0.060" (1.5 mm) thick, typically cut to either 1/4" (6 mm) wide (mid-bass) or 1/8" (3 mm) wide (tweeters) and more or less the length of the speaker.
Speaker wire is a passive electrical component described by its electrical impedance, Z. The impedance can be broken up into three properties which determine its performance: the real part of the impedance, or the resistance, and the imaginary component of the impedance: capacitance or inductance. The ideal speaker wire has no resistance ...
The Gauss Speaker Company, later known as Cetec Gauss, was a Sun Valley loudspeaker company. They were approved by Fender Musical Instruments Corporation [ 1 ] and found widespread use among rock musicians of the 1960s through the 1990s [cite?] .
Ads
related to: can speakers be repaired