enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Spin coating - Wikipedia

   en.wikipedia.org/wiki/Spin_coating

   Laurell Technologies WS-400 spin coater used to apply photoresist to the surface of a silicon wafer. Spin coating is a procedure used to deposit uniform thin films onto flat substrates. Usually a small amount of coating material in liquid form is applied on the center of the substrate, which is either spinning at low speed or not spinning at all.

3. Slot-die coating - Wikipedia

   en.wikipedia.org/wiki/Slot-die_coating

   A fluid reservoir to store the main supply of coating fluid for the system; A pump to drive the coating fluid through the system; A slot-die to distribute the coating fluid across the desired coating width before coating onto the substrate; A substrate mounting system to support the substrate in a controlled manner as it moves through the system

4. Non-evaporable getter - Wikipedia

   en.wikipedia.org/wiki/Non-Evaporable_Getter

   They are important tools for improving the performance of many vacuum systems. Sintered onto the inner surface of high vacuum vessels, the NEG coating can be applied even to spaces that are narrow and hard to pump out, which makes it very popular in particle accelerators where this is an issue. The main sorption parameters of the kind of NEGs ...

5. Deep clean your floors with an all-in-one vacuum spin ... - AOL

   www.aol.com/deep-clean-floors-one-vacuum...

   TL;DR: As of April 26, you can get the Elicto ES-800 5-in-1 Vacuum Spin Mop for just $229.99 with the code SPRING20. This multifunctional cleaning device usually costs $349, so you'll save $120.If ...

6. Liquid-ring pump - Wikipedia

   en.wikipedia.org/wiki/Liquid-ring_pump

   Single-stage vacuum pumps typically produce vacuum to 35 torr (mm Hg) or 47 millibars (4.7 kPa), and two-stage pumps can produce vacuum to 25 torr, assuming air is being pumped and the ring-liquid is water at 15 °C (59 °F) or less. Dry air and 15 °C sealant-water temperature is the standard performance basis, which most manufacturers use for ...

7. Sputter deposition - Wikipedia

   en.wikipedia.org/wiki/Sputter_deposition

   Sputter coating in scanning electron microscopy is a sputter deposition process [clarification needed] to cover a specimen with a thin layer of conducting material, typically a metal, such as a gold/palladium (Au/Pd) alloy. A conductive coating is needed to prevent charging of a specimen with an electron beam in conventional SEM mode (high ...