Search results
Results from the WOW.Com Content Network
MCA-Jet was a simpler system that sent the same air/fuel mixture to all intake and MCA-Jet valves. Each MCA-Jet valve is quite small and may be prone to carbon build-up, causing the MCA-Jet valve(s) to stick open. If a Mitsubishi-designed engine has low compression, the MCA-Jet valve(s) could be the cause. Each MCA-Jet valve and valve seat are ...
The SOHC eight-valve 4G54 (also known as the G54B) displaces 2.6 L (2,555 cc), with bore & stroke at 91.1 mm × 98 mm (3.59 in × 3.86 in). The G54B for the US market had a cylinder head with additional jet valves to improve emissions (MCA-Jet system).
The Mitsubishi Vulcan engine, identified by the code 2G2, is an iron-block twin cylinder engine with three main bearings, built by Mitsubishi Motors for kei car class vehicles from September 1972. It was an overhead camshaft design, and superseded the older two-stroke 2G1 series.
This version could switch between breathing through two or three valves per cylinder, to combine high top-end power with low-end drivability as well as allowing for economical operation. [1] It was a modification of Mitsubishi MCA-Jet technology which used a secondary intake valve to inject air into the engine for more efficient emissions ...
Those with the later, cleaner yet, "MCA-Jet" system were called G32B. Later, the G32B also came in a fuel injected , turbocharged model. For competition, a version of the 4G32 engine was made with a DOHC eight-valve cylinder head, and fitted with two twin-choke 40 mm (1.6 in) Solex sidedraft carburettors.
The ASME B16 Standardization of Valves Flanges, Fittings and Gaskets Committee, which operates under ASME’s Board on Pressure Technology Codes and Standards is responsible for standards covering valves, flanges, pipe fittings, gaskets and valve actuators for use in pressure services.
The quantity of bleed air flowing to the AC pack is regulated by the flow control valve (FCV). One FCV is installed for each PACK. A normally closed isolation valve prevents air from the left bleed system from reaching the right PACK (and vice versa), although this valve may be opened in the event of loss of one bleed system.
Closing the valve too quickly while trying to reduce power output could cause a lean die-out, where the airflow through the engine blows the flame out of the combustion chamber and extinguishes it. Adding fuel too quickly to increase power can damage the turbines due to excessive heat, or the sudden rise in combustion chamber pressure may cause ...