Search results
Results from the WOW.Com Content Network
Female Belling-Lee connector on a television set. The Belling-Lee connector (also type 9,52, but largely only in the context of its specification, IEC 61169, Part 2: Radio-frequency coaxial connector of type 9,52) [1] is commonly used in Europe, parts of Southeast Asia, and Australia, to connect coaxial cables with each other and with terrestrial VHF/UHF roof antennas, antenna signal ...
Coaxial cable, or coax (pronounced / ˈ k oʊ. æ k s /), is a type of electrical cable consisting of an inner conductor surrounded by a concentric conducting shield, with the two separated by a dielectric (insulating material); many coaxial cables also have a protective outer sheath or jacket.
The coaxial cable center conductor forms the pin, and cable dielectric extends up to the mating face of the connector. Thus, the male connector consists of only a body, which is generally crimped onto or screwed over the cable shielding braid, and a captive nut, neither of which require tight tolerances.
F connectors, also known as RF connectors, were the standard analog connector of the analog era in the Americas, used primarily with coaxial cable (RG-59 and RG-6), and have been repurposed for generic digital data connections. SCART was the standard connector of the analog era in Europe. S-Video was an improvement over the F connector.
Belling-Lee connectors Flex Type F connectors. A TV aerial plug is a connector used to connect coaxial cables with each other and with terrestrial VHF/UHF roof antennas, antenna signal amplifiers, CATV distribution equipment, TV sets and FM / DAB-radio receivers.
Some extended performance versions are rated to 10 GHz. The normally free part (a.k.a. plug) of a SMC connector that has a socket for the centre contact are the female connectors. The normally fixed part (a.k.a. jack) SMC connectors that has a pin for the centre contact are the male connectors. This is the reverse of most RF connectors.
The MCX connector is also being used on at least some of the new generation of mostly inexpensive software-defined oscilloscopes and/or signal generators such as the DS212. This is a low frequency application, at most a few MHz bandwidth, so the electrical performance characteristics are relatively unimportant, however the small size would ...
The conventionally used aid in cable fault testing and location is the cable test van. The van is installed with conventional cable measuring systems for quickly reaching the location of any cable fault. In 20 years that followed, over 2000 fault location vehicles were manufactured, more than half of which were intended for the former USSR.