Search results
Results from the WOW.Com Content Network
The prior Ethernet speed was 10 Mbit/s. Of the Fast Ethernet physical layers, 100BASE-TX is by far the most common. Fast Ethernet was introduced in 1995 as the IEEE 802.3u standard [ 1 ] and remained the fastest version of Ethernet for three years before the introduction of Gigabit Ethernet . [ 2 ]
A sped-up variant of the above, this directly corresponds to 10GE/40GE signalling at 2.5× speed. The higher symbol rate makes links more susceptible to errors. If the device and transceiver support dual-speed operation, it is possible to reconfigure an 100G port to downspeed to 40G or 4×10G.
The ISQ symbols for the bit and byte are bit and B, respectively.In the context of data-rate units, one byte consists of 8 bits, and is synonymous with the unit octet.The abbreviation bps is often used to mean bit/s, so that when a 1 Mbps connection is advertised, it usually means that the maximum achievable bandwidth is 1 Mbit/s (one million bits per second), which is 0.125 MB/s (megabyte per ...
Many device interfaces or protocols (e.g., SATA, USB, SAS, PCIe) are used both inside many-device boxes, such as a PC, and one-device-boxes, such as a hard drive enclosure. Accordingly, this page lists both the internal ribbon and external communications cable standards together in one sortable table.
Instructions per second (IPS) is a measure of a computer's processor speed. For complex instruction set computers (CISCs), different instructions take different amounts of time, so the value measured depends on the instruction mix; even for comparing processors in the same family the IPS measurement can be problematic.
This is a list of countries by Internet connection speed for average and median data transfer rates for Internet access by end-users. The difference between average ...
In computer networking, Gigabit Ethernet (GbE or 1 GigE) is the term applied to transmitting Ethernet frames at a rate of a gigabit per second. The most popular variant, 1000BASE-T , is defined by the IEEE 802.3ab standard.
It is complemented by the MAC layer and the logical link layer. An implementation of a specific physical layer is commonly referred to as PHY. The Ethernet physical layer has evolved over its existence starting in 1980 and encompasses multiple physical media interfaces and several orders of magnitude of speed from 1 Mbit/s to 800 Gbit/s.