Search results
Results from the WOW.Com Content Network
The various serial digital interface standards all use (one or more) coaxial cables with BNC connectors, with a nominal impedance of 75 ohms. This is the same type of cable used in analog composite video setups, which potentially makes for easier "drop in" equipment upgrades (though may be necessary for long runs at the higher bitrates for older oxidising or lower grade of cable to replaced ...
SMPTE 292 is a digital video transmission line standard published by the Society of Motion Picture and Television Engineers (SMPTE). This technical standard is usually referred to as HD-SDI; it is part of a family of standards that define a serial digital interface based on a coaxial cable, intended to be used for transport of uncompressed digital video and audio in a television studio ...
Note: Information in the chart has been superseded by the information in File:United States Frequency Allocations Chart 2016 - The Radio Spectrum.pdf, which was downloaded from the US Department of Commerce web site and archived at archive.org.
The SDI-12 Specification is maintained by a non-profit corporation called the SDI-12 Support Group. The most recent upgrade (Version 1.4) was made in July 2016. [3] The most recent version of the SDI-12 Specification (still version 1.4, with clarifications), was released on January 30, 2021.
Information in this chart supersedes that in File:United States Frequency Allocations Chart 2011 - The Radio Spectrum.pdf. Archived at archive.org on 2016-10-30. Licensing
Storing graphs or charts as images makes it harder to change (correct or translate) them. Wikicharts also help making sure to be consistent in font and size. Deutsch ∙ English ∙ español ∙ français ∙ македонски ∙ polski ∙ slovenščina ∙ +/−
An integrated receiver/decoder (IRD) is an electronic device used to pick up a radio-frequency signal and convert digital information transmitted in it. Consumer IRDs [ edit ]
The key SPI parameters are: the maximum supported frequency for the serial interface, command-to-command latency, and the maximum length for SPI commands. It is possible to find SPI adapters on the market today that support up to 100 MHz serial interfaces, with virtually unlimited access length.