Search results
Results from the WOW.Com Content Network
The temperature of the air entering the vehicle's interior can be controlled by using a valve limiting the amount of coolant that goes through the heater core. Another method is blocking off the heater core with a door, directing part (or all) of the incoming air around the heater core completely, so it does not get heated (or re-heated if the ...
The crankcase heater is normally on all the time, even when the unit is not running, though temperature sensors and set points may turn it off when not needed. A crankcase heater's sole purpose is to prevent refrigerant migration and mixing with crankcase oil when the unit is off, and to prevent condensation of refrigerant in the crankcase of a ...
Carburetor heat (usually abbreviated to 'carb heat') is a system used in automobile and piston-powered light aircraft engines to prevent or clear carburetor icing. It consists of a moveable flap which draws hot air into the engine intake.
The ignition source of a diesel engine is the heat generated by the compression of the air in the cylinder, rather than a spark as in gasoline engines. The dieseling phenomenon occurs not just because the compression ratio is sufficient to cause auto-ignition of the fuel, but also because a hot spot inside the cylinder (spark plug electrode ...
Electrical cord for powering a block heater. A block heater is used in cold climates to warm an engine prior to starting. They are mostly used for car engines; however, they have also been used in aircraft engines. The most common design of block heater is an electrical heating element embedded in the engine block.
Before you move: 3 items to check off your list Your current auto insurance will cover you in the short term as you move to your new state, but once you arrive, you'll need to update your policy.
(Being a heat exchanger, the velocity of air flow across the radiator has a major effect on its ability to dissipate heat.) Conversely, when cruising fast downhill on a motorway on a cold night on a light throttle, the thermostat will be nearly closed because the engine is producing little power, and the radiator is able to dissipate much more ...
Resistive-heat defoggers are usually equipped with an automatic timer to operate for a set time period of 10 to 15 minutes before switching off. This is because most defogging is achieved within that timeframe, after which the vehicle's heater has usually brought the interior of the vehicle to a warm enough temperature that the fog does not recur.