Search results
Results from the WOW.Com Content Network
Microcellular plastics, otherwise known as microcellular foam, is a form of manufactured plastic fabricated to contain billions of tiny bubbles less than 50 microns wide (typically 0.1–100 micrometers).
Two monoblock LNB can be connected to one receiving dish using Multi-satellite techniques. However, the expected results of such connections may vary or be sub-optimal. The results may yield low-level signals from some or all of the satellites or it may work well in certain geographically favorable locations.
A monoblock (or monobloc) LNB is a single unit comprising two, three or four LNBs and a DiSEqC switch, designed to receive signals from two, three or four satellites spaced close together and to feed the selected signal to the receiver. The feedhorns of the two LNBs are at a fixed distance apart for reception of satellites of a particular ...
5 Layer co-extrusion of cosmetic "squeeze" tube Typical liquid packaging board. Multi-layered packaging are multilayer or composite materials using innovative technologies aimed to give barrier properties, strength and storage stability to food items, new materials as well as hazardous materials.
Monobloc (chair), a type of light-weight chair made of one piece of injection-moulded plastic; Also: Monobloc, a 2005 Argentine film; Antoinette Monobloc, a pre-WWI French military monoplane; Monoblock LNB, a type of low-noise block downconverter
The "blockiness" of a copolymer is a measure of the adjacency of comonomers vs their statistical distribution. Many or even most synthetic polymers are in fact copolymers, containing about 1-20% of a minority monomer.
The Plastic vs. Paper Straw Debate, Explained. Chad de Guzman. February 12, 2025 at 10:27 AM.
Draft angle design is an important factor when designing plastic parts. Because of shrinkage of plastic material, injection molded parts have a tendency to shrink onto a core. This creates higher contact pressure on the core surface and increases friction between the core and the part, thus making ejection of the part from the mold difficult.