enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   Hole punch. Three different international-standard two-hole punches. A hole punch, also known as hole puncher, or paper puncher, is an office tool that is used to create holes in sheets of paper, often for the purpose of collecting the sheets in a binder or folder (such collected sheets are called loose leaves).

3. Ring binder - Wikipedia

   en.wikipedia.org/wiki/Ring_binder

   The most common type in Canada and the United States is a three-ring system for letter size pages (8 + 1 ⁄ 2 by 11 inches or 220 mm × 280 mm), whose size is similar to ISO 216-based A4 size. A standard 8 + 1 ⁄ 2 by 11 inches (220 mm × 280 mm) sheet of paper has three holes with spacing of 4 + 1 ⁄ 4 inches (110 mm).

4. Knockout punch - Wikipedia

   en.wikipedia.org/wiki/Knockout_punch

   A 3/4 inch conduit size punch actually punches a hole that is approximately 1.1 inches diameter for 3/4 nominal size conduit. A dimensional size punch makes a hole very close to the indicated size. Punch sets are available on both imperial and metric sizes. Chassis punches are available in a number of shapes, round being the most common.

5. Comb binding - Wikipedia

   en.wikipedia.org/wiki/Comb_binding

   Comb binding (sometimes referred to as "cerlox" or "surelox" binding) is one of many ways to bind pages together into a book. This method uses round plastic spines with 19 rings (for US Letter size) or 21 rings (for A4 size) and a hole puncher that makes rectangular holes. Comb binding is sometimes referred to as plastic comb binding or spiral ...

6. Loose leaf - Wikipedia

   en.wikipedia.org/wiki/Loose_leaf

   In North America, 3-hole binders for letter-size papers typically have a width of 1/2 inch, 1 inch, 1.5 inches, 2 inches, 3 inches or 4 inches; in ISO system, binders typically have a width of less than 3 cm. “Discbound” loose leaf systems, which uses separate “discs” to hold covers and pages. Staples and Office Depot sell discbound ...

7. Punching - Wikipedia

   en.wikipedia.org/wiki/Punching

   Usually, the punch and die are close to the same dimensions, creating a sheared edge when they meet. A punch that is significantly smaller than the die can be used to produce an extruded hole where the punch displaces the punched material to the sides, forming a tube perpendicular to the punched sheet. [2] [3]