Search results
Results from the WOW.Com Content Network
The butterfly valve often contains a small "idle cutout", a hole that allows small amounts of fuel/air mixture into the engine even when the valve is fully closed, or the carburetor has a separate air bypass with its own idle jet. If the engine is operating under light or no load and low or closed throttle, there is high manifold vacuum.
Swirl flap principle in a four-valve engine. A swirl flap is a small butterfly valve fitted to four-stroke internal combustion engines with at least two intake valves.It is installed inside or just before one of a cylinder's two intake ports, allowing to throttle its intake port's air flow, causing a swirl in the other intake port not fitted with a swirl flap.
In fuel injected engines, the throttle body is the part of the air intake system that controls the amount of air flowing into the engine, in response to driver accelerator pedal input in the main. The throttle body is usually located between the air filter box and the intake manifold, and it is usually attached to, or near, the mass airflow sensor.
Carburetors used as intake runners A cutaway view of the intake of the original Fordson tractor (including the intake manifold, vaporizer, carburetor, and fuel lines). An inlet manifold or intake manifold (in American English) is the part of an internal combustion engine that supplies the fuel/air mixture to the cylinders. [1]
The ACIS/TVIS System. Acoustic Control Induction System, or ACIS, is an implementation of a variable-length intake manifold system designed by Toyota.. Simply put, the ACIS system uses a single intake air control valve located in the intake to vary the length of the intake tract in order to optimize power and torque, as well as provide better fuel efficiency and reduce intake "roar".
Choke valve, Butterfly valve used to limit air intake in internal combustion engine. (Not to be confused with choke valves used in industrial flow control, above.) Clapper valve: a type of check valve used in the Siamese fire appliance to allow only one hose to be connected instead of two (the clapper valve blocks the other side from leaking out)
The actuator consists of a linear servo actuator servomotor that controls a plunger which varies air flow through the throttle body. The position of the servomotor and hence the amount of air bypass is controlled digitally by the engine ECU. This allows the engine's idle speed to be maintained constant.
Most choke valves in engines are butterfly valves mounted upstream of the carburetor jet to produce a higher partial vacuum, which increases the fuel draw. [ 1 ] In heavy industrial or fluid engineering contexts, including oil and gas production, a choke valve or choke is a particular design of valve with a solid cylinder placed inside another ...