enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   The term fine adjustment screw typically refers to screws with threads from 40–100 TPI (Threads Per Inch) (0.5 mm to 0.2 mm pitch) and ultra fine adjustment screw has been used to refer to 100–254 TPI (0.2 mm to 0.1 mm pitch). These screws are most frequently used in applications where the screw is used to control fine motion of an object.

3. The Crane Group Companies - Wikipedia

   en.wikipedia.org/wiki/The_Crane_Group_Companies

   The Crane Group Companies (also known as Crane Group) of Columbus, Ohio, USA, is a holding company of operating units primarily involved in the manufacturing and distribution of building products.

4. Bargeboard - Wikipedia

   en.wikipedia.org/wiki/Bargeboard

   Bargeboard, 1908 illustration. A bargeboard or rake fascia is a board fastened to each projecting gable of a roof to give it strength and protection, and to conceal the otherwise exposed end grain of the horizontal timbers or purlins of the roof.

5. Fastener - Wikipedia

   en.wikipedia.org/wiki/Fastener

   B18.3 Socket Cap, Shoulder, Set Screws, and Hex Keys (Inch Series) B18.6.1 Wood Screws (Inch Series) B18.6.2 Slotted Head Cap Screws, Square Head Set Screws, And Slotted Headless Set Screws (Inch Series) B18.6.3 Machine Screws, Tapping Screws, and Metallic Drive Screws (Inch Series) B18.18 Quality Assurance For Fasteners

6. Fascia (architecture) - Wikipedia

   en.wikipedia.org/wiki/Fascia_(architecture)

   Fascia (/ ˈ f eɪ ʃ ə /) is an architectural term for a vertical frieze or band under a roof edge, or which forms the outer surface of a cornice, visible to an observer. [ 1 ] Typically consisting of a wooden board, unplasticized PVC (uPVC), or non-corrosive sheet metal, many of the non-domestic fascias made of stone form an ornately carved ...

7. Bolt (fastener) - Wikipedia

   en.wikipedia.org/wiki/Bolt_(fastener)

   Where a fastener forms its own thread in the component being fastened, it is called a screw. [3] This is most obviously so when the thread is tapered (i.e. traditional wood screws), precluding the use of a nut, [3] or when a sheet metal screw or other thread-forming screw is used. A screw must always be turned to assemble the joint.