enow.com Web Search

  1. Ads

    related to: surge protector switched vs unswitched

Search results

  1. Results from the WOW.Com Content Network
  2. Power strip - Wikipedia

    en.wikipedia.org/wiki/Power_strip

    A North American power strip with two USB power ports that includes a built in surge protector. A power strip (also known as a multi-socket, power board and many other variations [a]) is a block of electrical sockets that attaches to the end of a flexible cable (typically with a mains plug on the other end), allowing multiple electrical devices to be powered from a single electrical socket.

  3. Surge protector - Wikipedia

    en.wikipedia.org/wiki/Surge_protector

    Surge Protection Device (SPD) for installation in a low-voltage distribution board. A surge protector (or spike suppressor, surge suppressor, surge diverter, [1] surge protection device (SPD), transient voltage suppressor (TVS) or transient voltage surge suppressor (TVSS)) is an appliance or device intended to protect electrical devices in alternating current (AC) circuits from voltage spikes ...

  4. Switched-mode power supply - Wikipedia

    en.wikipedia.org/wiki/Switched-mode_power_supply

    In contrast, a linear power supply regulates the output voltage by continually dissipating power in the pass transistor. The switched-mode power supply's higher electrical efficiency is an important advantage. Switched-mode power supplies can also be substantially smaller and lighter than a linear supply because the transformer can be much smaller.

  5. Safeguard Your Electronics With These Power Strips and Surge ...

    www.aol.com/avoid-frying-devices-power-strips...

    8-Outlet 6-Foot Extension Cord Power Strip. Bestek’s 8-Outlet surge protector is ideal as an accessible, under-desk power solution. We found that eight outlets were more than enough for a fully ...

  6. Inrush current limiter - Wikipedia

    en.wikipedia.org/wiki/Inrush_current_limiter

    The most popular application is the inrush protection of the AC current in switching power supplies (SPS). The primary reason for having surge current suppression in a SPS is to protect the diode bridge rectifier as the input or charging capacitor is initially charged. This capacitor draws significant current during the first half AC cycle and ...

  7. Uninterruptible power supply - Wikipedia

    en.wikipedia.org/wiki/Uninterruptible_power_supply

    Offline/standby UPS: The green line illustrates the flow of electric power. Typical protection time: 5–20 minutes. Capacity expansion: Usually not available. The offline/standby UPS offers only the most basic features, providing surge protection and battery backup. The protected equipment is normally connected directly to incoming utility power.

  8. Inrush current - Wikipedia

    en.wikipedia.org/wiki/Inrush_current

    Inrush current, input surge current, or switch-on surge is the maximal instantaneous input current drawn by an electrical device when first turned on. Alternating-current electric motors and transformers may draw several times their normal full-load current when first energized, for a few cycles of the input waveform.

  9. Surge protection device - Wikipedia

    en.wikipedia.org/?title=Surge_protection_device&...

    Retrieved from "https://en.wikipedia.org/w/index.php?title=Surge_protection_device&oldid=353427602"

  1. Ads

    related to: surge protector switched vs unswitched