Search results
Results from the WOW.Com Content Network
The Hypertext Transfer Protocol uses the keyword "Keep-Alive" in the "Connection" header to signal that the connection should be kept open for further messages (this is the default in HTTP 1.1, but in HTTP 1.0 the default was to use a new connection for each request/reply pair). [8] Despite the similar name, this function is entirely unrelated.
If the client supports keep-alive, it adds an additional header to the request: Connection: keep-alive When the server receives this request and generates a response, if it supports keep-alive then it also adds the same above header to the response. Following this, the connection is not dropped, but is instead kept open. When the client sends ...
The range header is used by HTTP clients to enable resuming of interrupted downloads, or split a download into multiple simultaneous streams. 207 Multi-Status (WebDAV; RFC 4918) The message body that follows is by default an XML message and can contain a number of separate response codes, depending on how many sub-requests were made. [7]
Check the physical connection - A loose cable or cord can often be the cause of a connection problem. Make sure everything is securely connected to the wall and device. 3. Reboot your modem/router - Sometimes the old "turn it off and on again" approach actually does work! Just wait about five minutes before turning it back on to make sure ...
In HTTP version 1.x, header fields are transmitted after the request line (in case of a request HTTP message) or the response line (in case of a response HTTP message), which is the first line of a message. Header fields are colon-separated key-value pairs in clear-text string format, terminated by a carriage return (CR) and line feed (LF ...
A BGP speaker sends 19-byte keep-alive messages every 30 seconds ... Message Header Error: 1: Connection Not Synchronized ... The router may have to keep more than ...
When ECN is successfully negotiated, an ECN-aware router may set a mark in the IP header instead of dropping a packet in order to signal impending congestion. The receiver of the packet echoes the congestion indication to the sender, which reduces its transmission rate as if it detected a dropped packet.
View the full headers to find out where an email was delayed or if the real sender disguised their email address. View the full header of an email. 1. Click an email to open it. 2. Click the More drop-down in the top menu. 3. Select View Message Source. Use header info to investigate problems. See where an email was delayed