Search results
Results from the WOW.Com Content Network
A typical phase diagram.The solid green line applies to most substances; the dashed green line gives the anomalous behavior of water. In thermodynamics, the triple point of a substance is the temperature and pressure at which the three phases (gas, liquid, and solid) of that substance coexist in thermodynamic equilibrium. [1]
Another type of binary phase diagram is a boiling-point diagram for a mixture of two components, i. e. chemical compounds. For two particular volatile components at a certain pressure such as atmospheric pressure , a boiling-point diagram shows what vapor (gas) compositions are in equilibrium with given liquid compositions depending on temperature.
At the triple point, all three phases can coexist. However, the liquid–vapor boundary terminates in an endpoint at some critical temperature T c and critical pressure p c. This is the critical point. The critical point of water occurs at 647.096 K (373.946 °C; 705.103 °F) and 22.064 megapascals (3,200.1 psi; 217.75 atm; 220.64 bar). [3]
In the diagram for CO 2 the triple point is the point at which the solid, liquid and gas phases come together, at 5.2 bar and 217 K. It is also possible for other sets of phases to form a triple point, for example in the water system there is a triple point where ice I , ice III and liquid can coexist.
This definition is clearly parallel to the definition of an ordinary critical point as the point at which two-phase coexistence terminates. A point of three-phase coexistence is termed a triple point for a one-component system, since, from Gibbs' phase rule, this condition is only achieved for a single point in the phase diagram (F = 2-3+1 =0 ...
By controlling the temperature and the pressure, the system can be brought to any point on the phase diagram. From a point in the solid stability region (left side of the diagram), increasing the temperature of the system would bring it into the region where a liquid or a gas is the equilibrium phase (depending on the pressure).
In thermodynamics, a critical line is the higher-dimensional equivalent of a critical point. [1] It is the locus of contiguous critical points in a phase diagram.These lines cannot occur for a single substance due to the phase rule, but they can be observed in systems with more variables, such as mixtures.
Epsilon was chosen for the new phase to correspond with the HCP form of cobalt. [ 1 ] The triple point between the alpha, gamma and epsilon phases in the unary phase diagram of iron has been calculated as T = 770 K and P = 11 GPa, [ 2 ] although it was determined at a lower temperature of T = 750 K (477 °C) in Figure 1.