Search results
Results from the WOW.Com Content Network
Differential pressure is the difference in pressure between two points. Differential pressure sensors are used to measure many properties, such as pressure drops across oil filters or air filters, fluid levels (by comparing the pressure above and below the liquid) or flow rates (by measuring the change in pressure across a restriction ...
A DP cell is a device that measures the differential pressure between two inputs. [1]Example: To measure the pressure difference between a container (or vessel) and the surrounding atmosphere, you may connect 'Hi' port of the DP-cell to a fitting that enters the vessel, using suitable tubing.
A transducer is a device that converts energy from one form to another. Usually a transducer converts a signal in one form of energy to a signal in another. [1] Transducers are often employed at the boundaries of automation, measurement, and control systems, where electrical signals are converted to and from other physical quantities (energy, force, torque, light, motion, position, etc.).
The pressure differential is typically measured using diaphragm pressure transducers with digital readout. Since these meters have significantly lower permanent pressure losses than orifice meters, Dall tubes are widely used for measuring the flow rate of large pipeworks.
An open (differential) mercury pressure gauge. A mercury pressure gauge is a type of manometer using mercury as the working fluid. The most basic form of this instrument is a U-shaped glass tube filled with mercury. More complex versions deal with very high pressure or have better means of filling with mercury.
The meter is "read" as a differential pressure head in cm or inches of water. Video of a Venturi meter used in a lab experiment Idealized flow in a Venturi tube. The Venturi effect is the reduction in fluid pressure that results when a moving fluid speeds up as it flows from one section of a pipe to a smaller section.
Example 3.5 and p.116 Bernoulli's principle can also be derived directly from Isaac Newton's second Law of Motion. When fluid is flowing horizontally from a region of high pressure to a region of low pressure, there is more pressure behind than in front. This gives a net force on the volume, accelerating it along the streamline. [a] [b] [c]
Converting the sensor's electrical output (for example V) to the measured units (for example K) requires dividing the electrical output by the slope (or multiplying by its reciprocal). In addition, an offset is frequently added or subtracted. For example, −40 must be added to the output if 0 V output corresponds to −40 C input.