Ads
related to: how to test a coil for spark plug resistance specifications
Search results
Results from the WOW.Com Content Network
An ignition coil is used in the ignition system of a spark-ignition engine to transform the battery voltage to the much higher voltages required to operate the spark plug(s). The spark plugs then use this burst of high-voltage electricity to ignite the air-fuel mixture. The ignition coil is constructed of two sets of coils wound around an iron ...
An ignition magneto (also called a high-tension magneto) is an older type of ignition system used in spark-ignition engines (such as petrol engines). It uses a magneto and a transformer to make pulses of high voltage for the spark plugs. The older term "high-tension" means "high-voltage". [1]
Spark plug wires (also called high tension leads) are electrical cables used by older internal combustion engines to transmit high-voltage electricity from the distributor to the spark plugs. Tension in this instance is a synonym for voltage. High tension may also be referred to as HT. [1] Many modern engines use coil-on-plug ignition, a design ...
Spark plug with single side electrode An electric spark on the spark plug. A spark plug (sometimes, in British English, a sparking plug, [1] and, colloquially, a plug) is a device for delivering electric current from an ignition system to the combustion chamber of a spark-ignition engine to ignite the compressed fuel/air mixture by an electric spark, while containing combustion pressure within ...
A variation coil-on-plug ignition has each coil handle two plugs, on cylinders which are 360 degrees out of phase (and therefore reach top dead center (TDC) at the same time); in the four-cycle engine this means that one plug will be sparking during the end of the exhaust stroke while the other fires at the usual time, a so-called "wasted spark ...
The discharge capacitor within the CD ignition had the ability to provide a powerful spark in excess of 4 times the spark power of the Kettering system using the same coil, with the exception that spark energy could be maintained at high rpm unlike the Kettering system. The Hyland unit consumed only four amperes at 5000rpm (8cyl) or 10,000rpm ...
A wasted spark system is a type of ignition system used in some four-stroke cycle internal combustion engines. In a wasted spark system, the spark plugs fire in pairs, with one plug in a cylinder on its compression stroke and the other plug in a cylinder on its exhaust stroke. The extra spark during the exhaust stroke has no effect and is thus ...
When it is time for a spark plug to fire, the rotor (the blue bar shown in the distributor in the figure above) connects the center electrode of the distributor cap to an electrode connected to a spark plug wire. This occurs simultaneously with the points opening and the coil delivering a high voltage to the center electrode.
Ads
related to: how to test a coil for spark plug resistance specifications