Search results
Results from the WOW.Com Content Network
UTM zones on an equirectangular world map with irregular zones in red and New York City's zone highlighted. The first part of an MGRS coordinate is the grid-zone designation. The 6° wide UTM zones, numbered 1–60, are intersected by latitude bands that are normally 8° high, lettered C–X (omitting I and O).
The projection from spheroid to a UTM zone is some parameterization of the transverse Mercator projection. The parameters vary by nation or region or mapping system. Most zones in UTM span 6 degrees of longitude, and each has a designated central meridian. The scale factor at the central meridian is specified to be 0.9996 of true scale for most ...
A projected coordinate system – also called a projected coordinate reference system, planar coordinate system, or grid reference system – is a type of spatial reference system that represents locations on Earth using Cartesian coordinates (x, y) on a planar surface created by a particular map projection. [1]
While you will see the MGRS grid zone listed with UTM in some commerical GIS (e.g. ArcGIS's Military Analyst extension), the fact remains that, as defined by the United States Geological Survey and the National Geospatial-Intelligence Agency, UTM has no "latitude zone".
Under the Chairman of the Joint Chiefs of Staff Instruction CJCSI 3900.01C dated 30 June 2007, GARS was adopted for use by the US DoD as "the “area-centric” counterpart to the “point-centric” MGRS". It uses the WGS 1984 Datum and is based on lines of longitude (LONG) and latitude (LAT). It is intended to provide an integrated common ...
(modern) UTM – Universal Transverse Mercator: Is a discretization of the continuous UTM grid, with a kind of 2-level hierarchy, where the first level (coarse grain) correspond to the "UTM zones with latitude bands" (the MGRS ), use the same 60 cylinders as reference-projection objects.
[20] [21] The six-degree zone width of UTM strikes a balance between the frequency of these discontinuities versus distortion of scale, which would increase unacceptably if the zones were made wider. (UTM further uses a 0.9996 scale factor at the central meridian, growing to 1.0000 at two meridians offset from the center, and increasing toward ...
The difference between UPS grid north and true north can therefore be anything up to 180°—in some places, grid north is true south, and vice versa. UPS grid north is arbitrarily defined as being along the prime meridian in the Antarctic and the 180th meridian in the Arctic; thus, east and west on the grids when moving directly away from the ...