Search results
Results from the WOW.Com Content Network
A Leupold telescopic sight mounted on a dovetailed rifle receiver via two scope rings From left: A sketch of a cross section on a Zeiss rail and ring mount, both with a Picatinny rail interface. Scope mounts are rigid implements used to attach (typically) a telescopic sight or other types of optical sights onto a firearm .
The Marlin Model 336 is a lever-action rifle and carbine made by Marlin Firearms. Since its introduction in 1948, it has been offered in a number of different calibers and barrel lengths, but is commonly chambered in .30-30 Winchester or .35 Remington , using a 20- or 24-inch barrel.
Most ACOG models, when mounted to a carry handle, have an open space through the mount to allow the use of the rifle's iron sights without removing the scope. [citation needed] Others include Docter or Trijicon [10] reflex sights mounted on top, such as the TA11SDO (SU-258/PVQ) and the TA648MGO (SU-260P). [11]
The mount is found on the left side of the rifle receiver, with machined cutouts for reduced weight and ease of installation; an example is the PSO-1 optical sight. Similar rails can also be found on rifles such as the Dragunov sniper rifle (SVD), the PSL rifle , the PKM as well as some AK series assault rifles from 1954 onwards.
The scope base is the attachment interface on the rifle's receiver, onto which the scope rings or scope mount are fixed. Early telescopic sights almost all have the rings that are fastened directly into tapped screw holes on the receiver, hence having no additional scope base other than the receiver top itself.
A rail system mounted on top of a SIG SG 550 A dovetail rail on a rifle receiver for mounting a sight. A rail integration system (RIS; also called a rail accessory system (RAS), rail interface system, rail system, mount, base, gun rail, or simply a rail [1]) is a generic term for any standardized attachment system for mounting firearm accessories via bar-like straight brackets (i.e. "rails ...
The locking bar system allows for even stress to be distributed and prevent canting of the scope mount. Another form of scope canting is caused by the rings themselves. Many Weaver-type mounts, including many Picatinny-type scope rings and even the Redfield Type, have either two or four screws on top of the scope ring that hold the scope in place.
Note knurled nut holding in the replaceable front sight insert. A globe sight is a front sight component used to assist the aiming of a gun/device, usually those intended to launch projectiles, such as firearms, airguns, and crossbows. It is found in particular as a front sight element on rifles. To obtain a usable sighting line, the diopter ...