Search results
Results from the WOW.Com Content Network
The drill can accommodate a drill bit that is up to 30 feet (9.1 m) in diameter and move dirt at a rate of up to 5 cubic yards (3.8 m 3) per rotation, depending on diameter, or drill buckets with capacities up to 8 cubic yards (6.1 m 3). The rotary table has a 46 inches (120 cm) diameter, double-pinion ring gear driven by a six-speed ...
The top drive allows the drilling rig to drill the longer section of a stand of drill pipe in one operation. [1] A rotary table type rig can only drill 30-foot (9.1 m) (single drill pipe) sections of drill pipe whereas a top drive can drill 60–90-foot (18–27 m) stands (double and triple drill pipe respectively, a triple being three joints of drillpipe screwed together), depending on the ...
If the bit has a 1.5" cheek and a 4.5" lower shank, thus producing a 1:3 ratio of cheek to lower shank, while the ratio of the cheek to (upper + lower) shank is 1:4, and producing 4 pounds-force of pressure on the horse's mouth for every 1 pound-force (4 newtons per newton) placed on the reins. If the bit had 2" cheeks and 8" shank (ratio of 1: ...
Simple diagram of a drilling rig and its basic operation. The kelly drive is #19. A kelly drive is a type of well drilling device on an oil or gas drilling rig that employs a section of pipe with a polygonal (three-, four-, six-, or eight-sided) or splined outer surface, which passes through the matching polygonal or splined kelly (mating) bushing and rotary table.
At 2,500 pounds (1.1 t), the 9N could plow more than 12 acres (4.9 hectares) in a normal day pulling two 14-inch (360 mm) plows, [3] outperforming the tractive performance of the heavier and more expensive Farmall F-30 model. [3] The hitch's utility and simplicity have since made it an industry standard.
In this simple diagram of a drilling rig, #20 (in blue) is the rotary table. The kelly drive (#19) is inserted through the center of the rotary table and kelly bushings, and has free vertical (up & down) movement to allow downward force to be applied to the drill string, while the rotary table rotates it.
Harnesses from the front View of harness from above-rear. A horse harness is a device that connects a horse to a horse-drawn vehicle or another type of load to pull. There are two main designs of horse harness: (1) the breast collar or breaststrap, and (2) the full collar or collar-and-hames.
A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.