Search results
Results from the WOW.Com Content Network
A hydraulic cylinder is the actuator or "motor" side of this system. The "generator" side of the hydraulic system is the hydraulic pump which delivers a fixed or regulated flow of oil to the hydraulic cylinder, to move the piston. There are three types of pump widely used: hydraulic hand pump, hydraulic air pump, and hydraulic electric pump.
A fluid power system has a pump driven by a prime mover (such as an electric motor or internal combustion engine) that converts mechanical energy into fluid energy, Pressurized fluid is controlled and directed by valves into an actuator device such as a hydraulic cylinder or pneumatic cylinder, to provide linear motion, or a hydraulic motor or pneumatic motor, to provide rotary motion or torque.
CP is simple in design, and works like a pneumatic system. New hydraulic functions can easily be added and the system is quick in response. Constant pressure systems, unloaded. Same basic configuration as 'standard' CP system but the pump is unloaded to a low stand-by pressure when all valves are in neutral position.
In Ancient Greece, the Greeks constructed sophisticated water and hydraulic power systems. An example is a construction by Eupalinos, under a public contract, of a watering channel for Samos, the Tunnel of Eupalinos. An early example of the usage of hydraulic wheel, probably the earliest in Europe, is the Perachora wheel (3rd century BC). [19]
The most common vehicle uses of master cylinders are in brake and clutch systems.. In brake systems, the operated devices are cylinders inside brake calipers and/or drum brakes; these cylinders may be called wheel cylinders or slave cylinders, and they push the brake pads towards a surface that rotates with the wheel (this surface is typically either a drum or a disc, a.k.a. a rotor) until the ...
Telescopic cylinders must only be used in machinery as a device for providing force and travel. Side forces and moment loads must be minimized. Telescopic cylinders should not be used to stabilize a structural component. [4] Hydraulic telescopic cylinders are often limited to a maximum hydraulic pressure of 2000-3000 psi.
Is installed on the piston head. Prevents fluid from crossing the area of the piston head. Ensures that fluid does not leak from the cylinder and adequate pressure is maintained. [5] Wiper seal: Is installed on the outside of the cylinder. Its main function is to prevent dirt, debris, and other contaminants from entering the hydraulic system.
Hydrolock (a shorthand notation for hydrostatic lock or hydraulic lock) is an abnormal condition of any device which is designed to compress a gas by mechanically restraining it caused by a liquid entering the device.