Search results
Results from the WOW.Com Content Network
There are two of these half-power frequencies, one above, and one below the resonance frequency Δ ω = ω 2 − ω 1 , {\displaystyle \Delta \omega =\omega _{2}-\omega _{1}\,,} where Δ ω is the bandwidth, ω 1 is the lower half-power frequency and ω 2 is the upper half-power frequency.
The half-power point is the point at which the output power has dropped to half of its peak value; that is, at a level of approximately −3 dB. [1] [a]In filters, optical filters, and electronic amplifiers, [2] the half-power point is also known as half-power bandwidth and is a commonly used definition for the cutoff frequency.
An example of an analogue electronic band-pass filter is an RLC circuit (a resistor–inductor–capacitor circuit). These filters can also be created by combining a low-pass filter with a high-pass filter. [1] A bandpass signal is a signal containing a band of frequencies not adjacent to zero frequency, such as a signal that comes out of a ...
An RLC circuit (or LCR circuit) is an electrical circuit consisting of a resistor, an inductor, and a capacitor, connected in series or in parallel. The RLC part of the name is due to those letters being the usual electrical symbols for resistance , inductance and capacitance respectively.
The passband of a receiver is the range of frequencies it can receive when it is tuned into the desired frequency (channel). A bandpass-filtered signal (that is, a signal with energy only in a passband), is known as a bandpass signal , in contrast to a baseband signal . [ 1 ]
Half power may refer to: Half-power point, at which output power has dropped to half peak value, in filters, optical filters, electronic amplifiers, and antennas Half power frequency; Half power beam width; Square root, written in exponent notation as x 1/2
A resistor–inductor circuit (RL circuit), or RL filter or RL network, is an electric circuit composed of resistors and inductors driven by a voltage or current source. [1] A first-order RL circuit is composed of one resistor and one inductor, either in series driven by a voltage source or in parallel driven by a current source.
Most frequently this proportion is one half the passband power, also referred to as the 3 dB point since a fall of 3 dB corresponds approximately to half power. As a voltage ratio this is a fall to 1 / 2 ≈ 0.707 {\textstyle {\sqrt {1/2}}\ \approx \ 0.707} of the passband voltage. [ 1 ]