Search results
Results from the WOW.Com Content Network
The most common use of a pull switch is to operate a ceiling electric light. The ceiling fan and mechanical wall fans are also appliances often operated by pull switches. Pull switches may be either two-position (open or closed) or multi-position (allowing for different fan speeds or levels of illumination). Mounted inside a pull switch, there ...
The toggle light switch was invented in 1916 by William J. Newton. [2] As a component of an electrical wiring or home wiring system, the installation of light switches is regulated by some authority concerned with safety and standards. In different countries the standard dimensions of the wall mounting hardware (boxes, plates, etc.) may differ.
For dimmable fluorescent lamps (where it operates instead at 1-10 V, where 1 V is minimum and 0 V is off) the system is being replaced by DSI, which itself is in the process of being replaced by DALI. Examples for digital lighting control systems are: DALI based system. DSI based system; KNX based systems; Those are all wired lighting control ...
The timer may switch equipment on, off, or both, at a preset time or times, after a preset interval, or cyclically. A countdown time switch switches power, usually off, after a preset time. A cyclical timer switches equipment both on and off at preset times over a period, then repeats the cycle; the period is usually 24 hours or 7 days.
Power On (IEC 60417-5007) and Power Off (IEC 60417-5008) symbols are used to indicate positions of the rocker switch Power button marked with Standby symbol (IEC 60417-5009) turns the device on or off without fully disconnecting power supply. A power symbol is a symbol indicating that a control activates or deactivates a particular device.
A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...
A preheat fluorescent lamp "starter" (automatic starting switch) Before the 1960s, four-pin thermal starters and manual switches were used. [citation needed] A glow switch starter automatically preheats the lamp cathodes. It consists of a normally open bi-metallic switch in a small sealed gas-discharge lamp containing inert gas (neon or argon ...
The induction lamp, electrodeless lamp, or electrodeless induction lamp is a gas-discharge lamp in which an electric or magnetic field transfers the power required to generate light from outside the lamp envelope to the gas inside.