Search results
Results from the WOW.Com Content Network
It merged with Sanwa Denki Manufacturing in 1965 and then became part of the SMC Group. In January 1974, Sanwa entered production and sales of transmitters for radio-controlled models and in December, became a member of the Japan Radio Control Model Industrial Association (JRM). [1] In 1975, Sanwa became a division on its own, with an office in ...
A clamp meter. Any meter will load the circuit under test to some extent. For example, a multimeter using a moving coil movement with full-scale deflection current of 50 microamps (μA), the highest sensitivity commonly available, must draw at least 50 μA from the circuit under test for the meter to reach the top end of its scale. This may ...
A digital clamp meter A multimeter with built-in clamp. Pushing the large button at the bottom opens the lower jaw of the clamp, allowing the clamp to be placed around a conductor. An electrical meter with integral AC current clamp is known as a clamp meter, clamp-on ammeter, tong tester, or colloquially as an amp clamp.
Top: Pipe clamp; Upper row: F-clamp or bar clamp, one-handed bar clamp ("Quick Grip"), wooden handscrew; Lower row: spring clamp, C-clamp (G-clamp ), wooden cam clamp. A clamp is a fastening device used to hold or secure objects tightly together to prevent movement or separation through the application of inward pressure.
IEC 61107 or currently IEC 62056-21, was an international standard for a computer protocol to read utility meters. It is designed to operate over any media, including the Internet. A meter sends ASCII (in modes A..D) or HDLC (mode E) data to a nearby hand-held unit (HHU) using a serial port.
A clamp holder or clamp fastener is a piece of laboratory apparatus that is used to secure laboratory clamps, such as extension-type utility clamps, or other attachments to a retort stand or lab frame. [1] The material can be made up of brass, cast iron, stainless steel, aluminium or nickel-plated zinc. [2]
Despite continuing demand from customers, production was stopped in 2008, reportedly due to increasing problems with suppliers of mechanical parts. [16] The last meter to leave the factory was an AVOmeter Eight Mk 7 (Serial Number 6110-610/081208/5166) which was presented in February 2010 to the winner of a competition run by the Megger company.
A meter can be calibrated as a DC voltmeter if the resistance of the coil is known by calculating the voltage required to generate a full-scale current. A meter can be configured to read other voltages by putting it in a voltage divider circuit. This is generally done by placing a resistor in series with the meter coil.