Search results
Results from the WOW.Com Content Network
Rear overhang may present a problem in large vehicles such as buses. Long rear overhang would require the driver to pay attention to nearby vehicles when turning at 90 degrees. Since the rear overhang is outside the wheelbase, it may hit a vehicle in the adjacent lane, especially when turning 90 degrees right (in a right-hand drive country).
Some manufacturers will install a speed governor if a vehicle is ordered with tires rated below the vehicle's maximum speed. In some parts of the European Union, e.g. Germany, it is allowed to mount tires with a lower speed rating code if the car manufacturer specifies tires with a very high speed rating in the registration documents and the ...
β° = Breakover angle; C = Underside of chassis; W = Wheel; G = Ground; M = Midpoint of wheelbase Example of a vehicle at a significant breakover angle.. Breakover angle or rampover angle is the maximum possible supplementary angle (usually expressed in degrees) that a vehicle, with at least one forward wheel and one rear wheel, can drive over without the apex of that angle touching any point ...
Approach (α) and departure angle (β) of a vehicle. Approach angle is the maximum angle of a ramp onto which a vehicle can climb from a horizontal plane without interference. [1] It is defined as the angle between the ground and the line drawn between the front tire and the lowest-hanging part of the vehicle at the front overhang.
In the United States, an oversize load is a vehicle and/or load that is wider than 8 ft 6 in (2.59 m). Each individual state has different requirements regarding height and length (most states are 13 ft 6 in or 4.11 m tall), and a driver must purchase a permit for each state he/she will be traveling through.
Production car tires typically develop this maximum lateral force, or cornering force, at a slip angle of 6-10 degrees, although this angle increases as the vertical load on the tire increases. [ 1 ] Formula 1 car tires may reach a peak side force at 3 degrees [ 2 ]
The second test (the "skid trailer" test) is usually performed using a tow vehicle and trailer. The trailer is fitted with the tyres being tested and the average maximum braking force that can be applied through the tyres, under a high proportion (60 - 90%) of the tyres' maximum load, is measured as the combination travels at a constant speed ...
In the European community, tires that are not fit for a car's or motorcycle's particular maximum speed are illegal to mount. The sole exception are M+S tires, where a warning sticker stating the allowed maximum speed must be placed within clear sight of the driver inside the vehicle. I don't think this statement is correct for the whole EU.