Ads
related to: transmission starting in 2nd gear ratio sensor problemsseafoamworks.com has been visited by 10K+ users in the past month
969 E Main St, Columbus, OH · Directions · (614) 257-0248
Search results
Results from the WOW.Com Content Network
If the transmission control unit senses a critical fault during driving, it will activate an emergency operating mode: Upon hydraulic failures, it will stop shifting gears and permanently retain the currently selected gear; if the failure can be pinpointed to one of the internal hydraulic control valves, the transmission will continue shifting but stop using the affected gear(s).
This transmission has a separate oil for the differential in the transmission, so there are two fluid levels to check. The differential fluid is checked by unscrewing the speed sensor gear assembly and use it as a dipstick. The speed sensor gear assembly is located on top of the transmission just above the right inner CV joint.
Manual – the driver has to perform each gear change using a manually operated clutch; Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load; Basically there are two types of engine installation:
By selecting L from stationary, or before an upward gear change into 2nd gear, the transmission will become locked in 1st gear. By selecting L from D2 or D1 while in 2nd gear, the transmission will become locked in 2nd gear or from D2 or D1 when cruising below 55 m.p.h (88 k.p.h.) will effect an immediate downward change and lock in 2nd gear.
Activated by a toggle switch, Winter mode sets the gearbox to start off in 2nd gear, both in Drive and Reverse. This is designed to reduce wheelspin on icy surfaces. Also in "W" mode the transmission will shift at lower speeds. "S" mode is not sport but Sommer (German for summer) or Standard. With Jaguar XJR applications the switch is labelled ...
A direct-shift gearbox (DSG, German: Direktschaltgetriebe [1]) [2] [3] is an electronically controlled, dual-clutch, [2] multiple-shaft, automatic gearbox, in either a transaxle or traditional transmission layout (depending on engine/drive configuration), with automated clutch operation, and with fully-automatic [2] or semi-manual gear selection.
The police package (9C1) B-body cars featured a First Gear Block Out (FGBO) Plate on the transmission housing to prevent drivetrain damage. The shift point for first to second gear is about 43 MPH (69 km/h) while second to third gear shift point is about 83 MPH (134 km/h) assuming a 3.08:1 differential and a 5,500 RPM engine speed limit.
In some V8 installations a small control unit activates the kick down solenoid when the brake pedal is released so that the car moves off in 1st gear. Other attributes of this transmission include a 2-3 shift delay when the engine is cold in order to speed up catalyst warm-up. 4th gear is a 1:1 ratio.
Ads
related to: transmission starting in 2nd gear ratio sensor problemsseafoamworks.com has been visited by 10K+ users in the past month
969 E Main St, Columbus, OH · Directions · (614) 257-0248