enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Plug (sanitation) - Wikipedia

   en.wikipedia.org/wiki/Plug_(sanitation)

   A plug in sanitation is an object that is used to close a drainage outlet firmly. The insertion of a plug into a drainage outlet allows the container to be filled with water or other fluids. In contrast to screw on caps, plugs are pushed into the hole and are not put over the hole.

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   A plug is a short barbed fitting with a blank end that can only be used with PEX piping to end the continuation of a water line that is no longer in use due to tying in elsewhere within the system or to seal the end of a water line which may be used for future use in the case of additional facilities. All plugs are sealed watertight with a PEX ...

4. Scupper - Wikipedia

   en.wikipedia.org/wiki/Scupper

   A scupper is an opening in the side walls of a vessel or an open-air structure, which allows water to drain instead of pooling within the bulwark or gunwales of a vessel, or within the curbing or walls of a building. Ship's bulwark. 1. Gunwale, 2. Bulwark plating, 3. Flange, 4. Stanchion, 5. Stringer plate, 6. Stringer angle, 7. Sheerstrake.

5. Reduced pressure zone device - Wikipedia

   en.wikipedia.org/wiki/Reduced_pressure_zone_device

   Backflow preventers are categorized into three groupings: Assembly, Device or Method. With the exception of elimination, these are the only ways one can control backflow from taking place. The eight named backflow assemblies all have two resilient seated isolation/shut off valves with properly located test ports.

6. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

7. Plug nozzle - Wikipedia

   en.wikipedia.org/wiki/Plug_nozzle

   In this example the nozzle consists of a conical or bell shaped opening with a plug on a movable rod positioned in front of the nozzle. The plug looks similar to a poppet valve. The stem of the valve runs back through the body of the nozzle body to a "trigger", normally a long lever running down the back of the nozzle assembly.