Ads
related to: 12 inch subwoofer 1000w rms circuit
Search results
Results from the WOW.Com Content Network
The 1925 paper [1] of Chester W. Rice and Edward W. Kellogg, fueled by advances in radio and electronics, increased interest in direct radiator loudspeakers. In 1930, A. J. Thuras of Bell Labs patented (US Patent No. 1869178) his "Sound Translating Device" (essentially a vented box) which was evidence of the interest in many types of enclosure design at the time.
The term loudspeaker may refer to individual transducers (also known as drivers) or to complete speaker systems consisting of an enclosure and one or more drivers.. To adequately and accurately reproduce a wide range of frequencies with even coverage, most loudspeaker systems employ more than one driver, particularly for higher sound pressure level (SPL) or maximum accuracy.
The most common subwoofer driver sizes used for sound reinforcement in nightclubs, raves and pop/rock concerts are 10-, 12-, 15- and 18-inch models (25 cm, 30 cm, 38 cm, and 45 cm respectively). The largest available sound reinforcement subwoofers, 21-inch (53 cm) drivers, are less commonly seen. [citation needed]
A Speakon connector is designed with a locking system that may be designed for soldered or screw-type connections. Line connectors (usually FEMALE with the latch) mate with (usually MALE) panel connectors and typically a cable will have identical connectors at both ends.
Connecting a low-impedance load such as a loudspeaker (usually 4 to 8 Ω) to a line out will essentially short circuit the output circuit. Such loads are around 1/1000 the impedance a line out is designed to drive, so the line out is usually not designed to source the current that would be drawn by a 4 to 8 ohm load at normal line out signal ...
Chaz Lanier scored 29 points to lead No. 1 Tennessee over No. 23 Arkansas 76-52 on Saturday and tie for the best start to a season in program history. The Volunteers (14-0, 1-0 Southeastern ...
Ads
related to: 12 inch subwoofer 1000w rms circuit