Search results
Results from the WOW.Com Content Network
Dip soldering is used for both through-hole printed circuit assemblies, and surface mount. It is one of the cheapest methods to solder and is extensively used in the small scale industries of developing countries . Dip soldering is a manual equivalent of automated wave soldering. The apparatus required is just a small tank containing molten solder.
Sensors installed to a fixture to check selective solder machine parameters Selective soldering machine. Selective soldering is the process of selectively soldering components to printed circuit boards and molded modules that could be damaged by the heat of a reflow oven or wave soldering in a traditional surface-mount technology (SMT) or through-hole technology assembly processes.
Surface-mount technology (SMT), originally called planar mounting, [1] is a method in which the electrical components are mounted directly onto the surface of a printed circuit board (PCB). [2] An electrical component mounted in this manner is referred to as a surface-mount device ( SMD ).
High power light-emitting diodes (LEDs) can use 350 milliwatts or more in a single LED. Most of the electricity in an LED becomes heat rather than light – about 70% heat and 30% light. [1] If this heat is not removed, the LEDs run at high temperatures, which not only lowers their efficiency, but also makes the LED less reliable, shortens its ...
Solder paste is used in the manufacture of printed circuit boards to connect surface mount components to pads on the board. It is also possible to solder through-hole pin in paste components by printing solder paste in and over the holes. The sticky paste temporarily holds components in place; the board is then heated, melting the paste and ...
For premium support please call: 800-290-4726 more ways to reach us
Surface mount components, including resistors, transistors and an integrated circuit A PCB in a computer mouse: the component side (left) and the printed side (right) "Through hole" components are mounted by their wire leads passing through the board and soldered to traces on the other side.
Solder makes a strong electrical and mechanical connection. Point-to-point wiring is not suitable for automated assembly (though see wire wrap , a similar method that is) and is carried out manually, making it both more expensive and more susceptible to wiring errors than PCBs, as connections are determined by the person doing assembly rather ...