Search results
Results from the WOW.Com Content Network
The British Admiralty defined a fathom to be a thousandth of an imperial nautical mile (which was 6080 ft) or 6.08 feet (1.85 m). In practice the "warship fathom" of exactly 6 feet (1.8 m) was used in Britain and the United States. [11] No conflict between the definitions existed in practice, [citation needed] since depths on imperial nautical
Fathom: Length: Knot: Speed: League: Length: Nautical mile: Length: Rhumb: Angle: The angle between two successive points of the thirty-two point compass (11 degrees 15 minutes) (rare) [1] Shackle: Length: Before 1949, 12.5 fathoms; later 15 fathoms. [2] Toise: Length: Toise was also used for measures of area and volume Twenty-foot equivalent ...
fathom: fathom (none) fathom ≡ 6 ft 1.0 fathom (6.0 ft; 1.8 m) yard: yd yd assumes the international definition 1.0 yd (0.91 m) foot: ft (foot) ft long code "foot" outputs foot (and never feet) Use of ′ and ″ symbols violates MOSNUM so is not provided. 1.0 ft (0.30 m) ftin (feet and inches) ft m (foot m) inch: in in
It was 1 ⁄ 6 of a ligne or 1 ⁄ 864 of the smaller French foot. ligne: 1 ⁄ 144: 2.256 mm 88.81 thou 1 ⁄ 12 of a pouce. This corresponds to the line, a traditional English unit. pouce: 1 ⁄ 12: 27.07 mm 1.066 in 1 ⁄ 12 of a pied du roi. This corresponds to the inch, a traditional English unit. pied du roi: 1 32.48 cm 1.066 ft
A sailor and a man on shore, both sounding the depth with a line. Depth sounding, often simply called sounding, is measuring the depth of a body of water.Data taken from soundings are used in bathymetry to make maps of the floor of a body of water, such as the seabed topography.
A cable in this usage cable is a thick rope or by transference a chain cable. [1] The OED gives quotations from c. 1400 onwards. A cable's length (often "cable length" or just "cable") is simply the standard length in which cables came, which by 1555 had settled to around 100 fathoms (600 ft; 180 m) or 1 ⁄ 10 nautical mile (0.19 km; 0.12 mi). [1]
The values of the units varied according to location and epoch (e.g., in Aegina a pous was approximately 333 mm (13.1 in), whereas in Athens (Attica) it was about 296 mm (11.7 in)), [1] but the relative proportions were generally the same.
Some of these units are still in use, albeit standardised to SI/metric measurements. When the Royal Thai Survey Department began cadastral survey in 1896, Director R. W. Giblin, F.R.G.S., noted, "It so happens that 40 metres or 4,000 centimetres are equal to one sen," so all cadastral plans are plotted, drawn, and printed to a scale of 1:4,000. [2]